Vitek VT-8247 Инструкция по эксплуатации онлайн [6/40] 811743

ENGLISH

• Unpack the hot air styler and remove any stickers that can

prevent unit operation.

• Unwind the power cord completely.

• Install one of the attachments (8, 9, 10). To do this insert

the attachment into the installation place (1) and turn it

clockwise. If the attachment is set properly, you will hear the

release button (2) click.

• Before switching the unit on, make sure that your home

mains voltage corresponds to the unit operating voltage.

• Make sure that the operation mode switch (3) is set to the

position “0”.

• Insert the power plug into the mains socket.

• Use the switch (3) to set the required parameters of the air

flow, the indicator (4) will be glowing during the operation:

«0» – the hot air styler is off;

« » – «cool» air supply;

«1» – low air flow temperature;

«2» – high air flow temperature;

Note: During the first operation some foreign smell and a small

amount of smoke from the heating element are possible, this

is normal.

• After the hot air styler operation is finished, switch it off by

setting the switch (3) to the «0» position and unplug it.

• Wait till the hot air styler cools down.

• To remove the attachment, press and hold the attach-

ment release button (2) and turn the attachment counter-

clockwise.

Overheating protection

Overheating protection switches the hot air styler off if the tem-

perature of the outgoing air is above the limit. If the hot air styler

is switched off during operation, set

the switch (3) to the «0» position, unplug the unit and make

sure that the inlets and outlets are unblocked. Let the unit cool

down for 5-10 minutes and switch it on again. Do not block the

air inlets during the hot air styler operation and avoid getting of

hair into its air inlet.

CLEANING AND CARE

The hot air styler is intended for household use only.

• Set the switch (3) to the «0» position, disconnect the hot air

styler from the mains and let it cool down.

• To remove the attachment, press and hold the attachment

release button (2) and turn the attachment counterclockwise.

• Wipe the unit body (5) with a damp cloth and then wipe it dry.