Vitek VT-1951 Инструкция по эксплуатации онлайн [8/28] 811766

Vitek VT-1951 Инструкция по эксплуатации онлайн [8/28] 811766
8
ENGLISH
Battery replacement
When the batteries are low, the symbol «LO» will appear on
the display (6).
Open the battery compartment lid (7), replace the «AAA»
batteries with new ones, strictly following the polarity, and
close the battery compartment lid (7).
If you are not planning to use the scale for a long time,
remove the batteries from the battery compartment.
RECOMMENDATIONS
Try to install and use the scale in the same place.
Weigh yourself at the one and the same time of the day.
We recommend measuring the percentage of fat and wa-
ter in the evening before evening meal.
2-3 hours should pass after last meal.
At least 10-12 hours should pass after intensive physical
exercises.
Percentage of fat in the body depends on different fac-
tors and can change during the day.
When calculating percentage of fat and water of children
younger than 10 years the results may be inaccurate.
Professional sportsmen, people inclined to edemas and
people with nonstandard body proportions can show inac-
curate results of calculation of fat and water percentage.
Note: Fat and water percentage data can be calculated
only if personal data (sex, age, height) are entered correctly
and if you step on the scale barefeet.
WEIGHT MEASUREMENT
Weight measurement unit selection
To select the weight measurement unit, consequently
press the button (3) «Unit» on the bottom part of the
scale body.
Measurement units are shown on the display (6) with the
symbols:
«kg» – weight measurement in kilograms (12);
«lb» – weight in pounds (14);
«st» – weight in stones (14).
Place the scale on a flat solid surface; if the floor is un-
even or covered with carpet or rug, the weighing accu-
racy may decrease.
Be careful while stepping on the scale: step on the scale
first with one foot; make sure that the scale is steady and
only then step on it with the both feet.
Step on the scale and dispose your weight evenly. Stand
still while being weighted. Do not jump on the weighing
platform. The digital indications (8) on the display (6) will
show your weight in the selected measurement units.
ATTENTION!
If a symbol «Err» appeared on the display (6), it means
that the scale is overloaded.
Immediately step off the weighing platform (1) to avoid
damaging the scale.
The scale will be automatically switched off in 42 sec-
onds after switching on.
ENTERING PERSONAL DATA
Switch the scale on by pressing on the weighing platform
(1). Press the «SET» button (5), the flashing symbols
(8) on the display (6) will show one of the user numbers
«Р1», «Р2», ..., «Р13».
Select the desired user number by pressing the buttons
(4) «▲▼». You can enter and save data for 13 users. Con-
firm your selection of the user number by pressing the
«SET» button (5).
The flashing symbol of the user’s sex will be shown on
display (6). By pressing the buttons (4) «▲▼» select the
symbol (10) « » for woman or the symbol (11) « » for
man, press the «SET» button (5) to confirm.
The flashing digital indications of user’s height will be shown
on the display (6), the digital values of height are entered in
values corresponding to the selected weight measurement
units «kg/st/lb». If the weight measurement units (12) are
set in «kg», the user›s height values are entered in centime-
ters (9) «cm». Set the height values by pressing the buttons
(4) «▲▼», press the «SET» button (5) to confirm.
The flashing values of the user’s age (25) «Age» will ap-
pear on the display (6). Set the user›s age by pressing the
buttons (4) «▲▼», press the «SET» button (5) to confirm.
WEIGHT MEASUREMENT WITH CALCULATION
RESULTS
Switch the scale on by pressing on the weighing platform
(1). Press the «SET» button (5), the flashing symbols
(8) on the display (6) will show one of the user numbers
«Р1», «Р2», ..., «Р13».
Select the desired user number by pressing the buttons
(4) «▲▼». The user›s number symbol will appear on the
display (6).
Wait until the symbols «0.0 kg», «0.0 lb» or «0:0 st» ap-
pear on the display (6), depending on the selected mea-
surement units.
Step with your bare feet on the weighing platform (1) so
that your feet are on the contact areas (2), stay still during
the weight measurement and wait until the weight indica-
tions appear on the display (6).
Note: If you don’t step on the scale within 42 seconds, it will
switch off automatically.
Keep standing still on the weighing platform (1), the dis-
play (6) will show moving symbols «o...o», while the data
is being calculated.
The calculated data will be shown on the display (6) in the
following order:
«FAT» - fat tissue percentage (20);
«TBW» - water percentage (21);
« » - muscle bulk percentage (23);
« » - bone mass percentage (22);
«KCAL» - recommended daily calorie intake (24);
«BMI» - body mass index (15);
after the calculated results, your weight will be shown
once again;
after that the scale will switch off.
As a result of calculations, the display (6) can show the fol-
lowing symbols:
obesity symbol «OBESE» (16);
overnutrition symbol «OVERFAT» (17);
healthy body symbol «HEALTHY» (18);
excessive fat symbol «UNDER FAT» (19);
the appearance of the symbol «ErrL» indicates an error in
the percentage of body fat, or very low body fat.
the appearance of the symbol «ErrH» indicates an error
in the percentage of body fat, or very high body fat.
CALCULATION RESULTS
«FAT» - the result of calculating the percentage of fat tis-
sue in the body, this parameter is not constant and may
change during the day. The percentage of fat tissue in
the body depends on lifestyle, physical activity, general
health and the amount of fluid in the body.
When analyzing calculated readings of fat tissue in the
body, consider the following factors:
the fat percentage indications may be higher after hav-
ing a meal or a drink,
the fat percentage indications may be less after taking
a bath or a shower,
if the fluid content in the body decreases, then the fat
tissue percentage indications will change.
Скачать