Instrumax SNIPER 80 PLUS IM0129 Инструкция по эксплуатации онлайн [5/24] 818817

SNIPER 80

Press button (6) to set the reference from the front, rear, tri-

pod. When the end-piece is folded out fully, the reference rear

is set.

You will see the reference symbol on the display.

Selecting Units

Press and hold the button (5) for 2 sec. until the desired unit

is displayed.

Illumination

Press and hold the button (6) for 2 seconds to switch the illu-

mination on or off.

Clear-Key

Cancel the last action. Press button (7).

MEASUREMENTS

Single distance measurement

Press button and hold button ON (1) to activate the laser. Press

again to trigger the distance measurement. A beep will sound.

The result is displayed immediately.

Continuous Measurement

Press and hold button ON (1) for about 2 seconds to start

continuous measuring. That function allows to measure mini-

mum and maximum distances from the xed point. This func-

tion is widely used for diagonal measurements (maximum

value) or horizontal distances up to vertical plane (minimum

value). Minimum (5) and maximum (3) values will be shown

on the display.

FUNCTIONS

Area

Press the button (2) once.The symbol Area (4) is displayed.

Press button ON (1) to take the rst measurement (for exam-

ple, length). Measured value is displayed in line 3.

Press button ON (1) to take the second measurement (for ex-

ample, width). The result of measured area is displayed in the

line 2. The area result is displaye din the main line. Perimeter