Instrumax SNIPER 80 PLUS IM0129 Инструкция по эксплуатации онлайн [6/24] 818817

SNIPER 80

is displayed in the line 1.

Volume

For volume measurements, press button (2) twice until the

symbol (4) for volume measurement appears on the display.

Press button ON (1) to measure width, length and height.The

volume value will be displayed in the main display area (8).

Indirect measurement

Pythagorean measurement is used in the condition that the

objective needing to be measured is covered or has no effec-

tive reecting surface and can’t be measured directly.

Make sure you adhere to the prescribed sequence of mea-

surement:

All target points must be in a horizontal or vertical plane.

The best results are achieved when the instrument is rotated

about a xed point (e.g. rear part of the tool is attached to the

xed surface, e.g. wall).

Activate continious measurement function to take measure-

ments.

Distance that is necesary to be measured is blinking in the

icon 'triangle'. Press button ON for the measurements.

The result will be displayed in the main display area.

Timer

Use Timer for accurate measurement of big distances. Press

and hold button (3) to set the delay in 5 sec. When you

release the button, you will see time (in sec) (14) on the dis-

play. This time shows how many seconds we have to start

the measurement. Time reading of last 5 seconds goes with

sound alarm. The instrument will start the measurement after

the last sound alarm.

Memory

The tool stores the measured values (up to 60 values) on the

internal memory.

Press button (7) to display the rst stored value.

Press button (7) once again to enter into the stored values.

Choose the necessary value by pressing buttons (3) or (5).

Press and hold button (7) until you will hear a sound alarm to