SICCE GREEN RESET 25 литров с УФ-лампой ELAB01X Инструкция к товару онлайн [5/28] 825808

preferably lubricated (only with silicon grease) before

repositioning it (Fig. 3).

• Remove the sponges and wash them under running

water.

• Remove the grille on the bottom of the lter and rinse

it out under running water

(Mod. 25 - 40 only)

• Wash bio-balls only once a year so to allow the

biological ltration not to be interrupted

(Mod. 25 - 40

only)

• Then reassemble the lter following the above

procedures in reverse order.

• PLEASE, OIL PERIODICALLY THE METAL RODS

WITH THE OIL INCLUDED SO TO AVOID FRICTION

OR BREAKING OF THE SAME.

Winter season - The lter must be protected from

frost. During the winter season the lter should should

be switched off, emptied of all water, removed from

the garden and stored in a dry, sheltered place. It is

recommended to leave the lter open during storage.

UV-C lamp replacement

CAUTION: The replacement of the UV-C lamp has to

be done only by specialized personnel staff.

INSTRUCTIONS FOR THE CORRECT DISCHARGE

OF THE PRODUCT ACCORDING TO EU DIRECTI-

VE 2002/96/EC

When used or broken, the product does not have to be

discharged with the other waste. It can be delivered

to the specic electric waste collection centres or to

dealers who give this service. Discharge separately an

electric tool avoid negative consequences for the en-

vironment and for the Health and allows to regenerate

the materials so to have a great saving of energy and

resources.

WARRANTY

This product is guaranteed against defects of mate-

rials and workmanship for a period of 3 years from the

date of purchase, except the UV-C lamp and the O-

rings. The warranty certicate must be lled in by the

dealer and must accompany the pump if it is returned

for reparation, along with the cash register receipt or

similar document. The warranty covers the replace-

ment of the defective parts. In case of improper use,

tampering or negligence by the buyer or user, the gua-

rantee is void and expires immediately. The guarantee

is also void in absence of the cash register receipt or

similar document. The expenses for shipping the pro-

duct to and from the factory, or the repair station, have

to be paid by the buyer.

there are no leaks.

2. If everything is working and the water normally ows

through the lter, connect the plug of the UV-C Lamp and

verify that it is on through the light indicator (g. 1/E).

3. The lter can work 24 hours/day for the entire year

except if the temperature drops below 4°C. To avoid

damages, unplug the power and empty completely the

lter.

CONNECTING THE HOSES

The GREEN RESET lter requires three exible tubes

which are not included. One to connect the pump with

the inlet coupling (g. 1/A), another to ush the clean

water from the lter outlet (g. 1/B) back to the pond.

Another to connect the drainpipe (g. 1/C) dirty wa-

ter when sponges cleaning is done. This water can be

used as fertilizer. When installing Green Reset lter, it

is important that the exible hoses diameters are cor-

rectly sized. This will allow the pump to obtain maxi-

mum water ow performances. Always fasten the ho-

ses to the couplings with metal clamps (not included).

CLEANING OF THE SPONGES WITH THE SELF

CLEANING SYSTEM

GREEN RESET is equipped with a self-cleaning

system, that allows to clean the sponges without

opening the lter.

Proceed as follows:

• Lift completely the handle on the top of the lter (g.

4).

• Turn both the hand grips from the position “FILTER”

to the position “CLEAN” clockwise or anticlockwise

until the writing CLEAN corresponds to the small hole

in the handle (g. 5).

• Remove the cap (g. 6/A) from the debris outlet,

connect the stepped hose connector (g. 6/B) and

a exible tube (not compulsory). Position the tube

towards the plants/owers you would like to fertilize.

• Turn clockwise, with strength, the ow selector handle

to the “CLEAN” position (g 7).

• Push up and down the top handle (g. 8) to squeeze

the sponges. Repeat this operation until clean water

come out from the lter. When cleaning is completed,

rell the pond as you like.

• To settle the lter for normal operation, lift up

completely the top handle (g. 9/F).

• Turn both the hand grips from “CLEAN” position to

“FILTER” position (g. 10/G).

• Lower completely the top handle (g. 8/F).

• Turn the ow selector handle anticlockwise to the

“FILTER” position (g. 11/F).

• Remove the stepped hose connector (g. 6/L) from the

debris outlet and close it with the original cap (g. 6/I).

If the lter, after cleaning operations, is still blocked,

proceed with the lter maintenance.

FILTER MAINTENANCE

Cleaning and replacement of sponges.

The maintenance of the lter has to be done only if the

self-cleaning system cannot fully clean the sponges

because they are worn out or blocked.

CAUTION: Always disconnect the lter from the power

supply before any maintenance operations.

• Do not open the V-band (g. 1/M) before having

unplugged the pump and UV-C lamp.

• The cap of the UV-C lamp compartment can be

opened only by specialized personnel.

• Open the V-band (g. 1/M).

• Remove the lter dome with special care to do not

damage the OR gasket. This should be washed and

SICCE GREEN RESET 25 литров с УФ-лампой ELAB01X Инструкция к товару онлайн [5/28] 825808

Похожие устройства