Home
Главная
Al-Ko
Электрические
Comfort 36 E Combi Care 113465
Инструкция к AL-KO Comfort 36 E Combi Care 113465 Страница: 24

Al-Ko Comfort 36 E Combi Care 113465 Инструкция к AL-KO Comfort 36 E Combi Care 113465 онлайн [24/248] 827736

Al-Ko Comfort 36 E Combi Care 113465 Инструкция к AL-KO Comfort 36 E Combi Care 113465 онлайн [24/248] 827736

GB

24 COMBI-CARE 36 E comfort

Operation

Folding out the handlebar

Proceed in reverse order.

6.2 Adjusting the handlebar to the body

size(06)

1. Loosen the quick release on the rotary/snap-

in joints (06/1).

2. Turn the handlebar to the desired height

(pos.a) at the handle (06/2). The rotary

movement is limited by the end stops (06/3)

of the rotary/snap-in joint.

3. Tighten the quick releases (06/1).

6.3 Setting the working depth(07)

The setting of the working depth depends on:

■

Grass condition (well-kept: low working

depth, overgrown: large working depth)

■

Blade wear (new: low working depth, worn:

large working depth)

If the working depth is too large: The appliance

stands still and the motor does not run.

IMPORTANT!

Danger of damage to the

appliance

Setting the working depth

with the appliance running

causes damage.

■

Only set the working

depth when the motor

and blade system have

stopped.

1. Turn the adjuster wheel (07/1) to HIGH, i.e.

level1 on the working depth indicator (07/2).

The blade system is raised to the maximum.

2. Checking the working depth:

■

Start the appliance (see chapter 6.5

"Starting and stopping the motor (09)",

page24).

■

Move a little way onto the grass and

check the result. If the grass is too short

or irregularly scarified, the blade system

must be lowered.

3. Stop the appliance and wait until the blade

system has stopped.

4. Turn the adjuster wheel (07/1) a little towards

LOW, i.e. levels 2 to 5. The blade system is

lowered.

5. Repeat the previous steps until the grass is

uniformly scarified.

6.4 Establishing the mains connection (08)

1. Firmly plug the socket (08/1) of the mains

cable into the plug (08/2) on the motor

switch.

2. Clamp the mains cable (08/3) in the cable

strain relief (08/4) (pos.a, pos.b) so it cannot

be pulled off the motor switch.

6.5 Starting and stopping the motor (09)

IMPORTANT!

Danger of damage to the

appliance

The motor and blade sys-

tem can be damaged by

consecutively switching on

and off briefly several

times.

■

Only switch the motor

on when the blade sys-

tem has stopped.

Starting the motor

1. Press and hold the safety push switch (09/1)

(pos.a).

2. Pull the motor switch bracket (09/2) to the

handlebar (09/3) (pos.b). The motor and

blade system are started.

3. Release the safety push switch (09/1) and

hold the motor switch bracket (09/2).

NOTE

The motor switch bracket does not lock

in place. Hold it tight against the handle-

bar during the entire working period.

Stopping the motor

1. Release the motor switch bracket (09/2). It

automatically returns to the initial position

(pos.c).

The motor stops immediately. The blade system

keeps running until it stops.

Похожие устройства