WORX Professional WU326P 1010Вт, SDS Plus, 26мм, 5Дж, кейс WU326P Инструкция WU326P онлайн [7/16] 830502

ACCESSORIES

Auxiliary handle 1

SDS drill bits (6mm, 8mm, 10mm) 3

Chisel bit 1

We recommend that you purchase your accessories

from the same store that sold you the tool. Refer to

the accessory packaging for further details. Store

personnel can assist you and offer advice.

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the

instruction book carefully.

Action Figure

Inserting bits

Clean and lightly grease the bit with

the oil provided before inserting.

Insert the dust-free bit into the bit

holder with a twisting motion until it

latches. The bit locks itself. Check the

locking by pulling on the tool.

WARNING: Take care that

the dust protection cap is

not

damaged when changing tools.

See Fig. A

Removing bits

Retract back the bit holder locking

sleeve (2) and pull out the bit.

WARNING: Your new WORX

Rotary Hammer generates

powerful forces to get your job

done quickly and effectively.

These forces may cause inferior

quality SDS bits to break and

jam in the chuck. We therefore

recommend that only high qual-

ity SDS bits be used with this

tool.

See Fig. B

Adjusting the auxiliary handle

WARNING: Always use the

auxiliary handle.

See Fig. C

Operation

Function mode selection See Fig. D

On/off switch See Fig. E

Replacing the brushes See Fig. F

Function mode selection

The operation of the gearbox for each application

is set with the function mode selection switch (3).

To change between functions, depress the unlock-

ing button (4) and rotate the selector to the desired

operating mode.

Function WU326P

For drilling of concrete

or masonry.

For chiseling.

WARNING: The operating mode selector

switch may be actuated only at a stand-

still.

MAINTENANCE

Remove the plug from the socket before carry-

ing out any adjustment, servicing or mainte-

nance.

There are no user serviceable parts in your power

tool. Never use water or chemical cleaners to clean

your power tool. Wipe clean with a dry cloth. Always

store your power tool in a dry place. Keep the motor

ventilation slots clean. Keep all working controls free

of dust. Occasionally you may see sparks through

the ventilation slots. This is normal and will not dam-

age your power tool.

If the supply cord is damaged, it must be replaced by

the manufacturer, its service agent or similarly quali-

ﬁed persons in order to avoid a hazard.

ENVIRONMENTAL

PROTECTION

Disposal

The machine, its accessories and

packaging materials should be sorted for

environmentally friendly recycling.

The plastic components are labeled for

categorized recycling.

WORX Professional WU326P 1010Вт, SDS Plus, 26мм, 5Дж, кейс WU326P Инструкция WU326P онлайн [7/16] 830502

Похожие устройства