WORX Professional WU326P 1010Вт, SDS Plus, 26мм, 5Дж, кейс WU326P Инструкция WU326P онлайн [8/16] 830502

TROUBLE SHOOTING

The following table gives checks and actions that you can perform if your machine does not operate correctly.

If these do not identify/solve the problem, contact WORX Customer Service.

I would add a comment here to again recommend that you apply grease to the shank of every drill bit used.

Symptom Possible Cause Remedy

Machine fails to operate

No power supply to machine. Use another socket.

The brushes are worn out. Have a qualiﬁed person to check

them, and replace them if necessary.

The power and hammer

efﬁciency of the machine

is low.

Machine may be cold. Warm up the machine for 1-2

minutes until it reaches a proper

working temperature.

The connecting rod is broken (lacking

of grease oil or the gearbox is dirty).

Have a qualiﬁed person to replace it

if necessary and add grease oil.

There is no enough grease oil in the

gearbox.

Have a qualiﬁed person to add some

grease oil (about 2 or 3 bottle caps).

Your bit does not slide freely in the

chuck.

Clean the dust and debris inside the

chuck; Grease the shank of the bit if

necessary.

Your drill bit will not ﬁt into

the chuck easily

The chuck is dirty with dust and

debris.

Clean the dust and debris from

inside the chuck.

The shank of the bit is damaged or

distorted.

Change a new bit.

A drill bit has broken and the shank

has remained in the chuck.

Remove the chuck, and take out the

bit as shown in Fig. B, then clean the

chuck inside.

You cannot remove your

drill bit from the chuck