Briggs & Stratton S 1024 1696618 Инструкция к Briggs&Stratton S 1024 1696618 онлайн [16/252] 832276

Not for

Reproduction

Troubleshooting

Problem Cause Solution

The auger does not stop when the auger control is

released.

The control cable requires adjustment. SeeAdjust the Auger Control Cable.

The auger does not turn when the auger control is

engaged.

The control cable requires adjustment. SeeAdjust the Auger Control Cable.

The key is set to the OFF position. Turn the key to the ON position.

The primer button was not pushed 2-times before

the starter rope was pulled.

Push the primer button 2-times before you pull the

starter rope.

The fuel tank is empty. Fill the fuel tank with fresh fuel.

The choke is open. Turn the choke to the CLOSED position before you

pull the starter rope.

The engine is flooded. Turn the choke to open position. Pull the starter

rope several times until the engine starts.

The engine does not start.

Water is in the fuel or old fuel. Fill the fuel tank with fresh fuel.

The chute rotation or deflector adjustment does not

work.

The chute or deflector is frozen. Keep the snowthrower in a warm area until the

snow or ice melts.

Incorrect oil Change oil to lighter viscosity.The engine is hard to start or operates poorly.

The choke control is set incorrectly. As the engine warms, gradually open the choke

control.

Too much vibration. Loose or damaged parts Stopthe snowthrower immediately. Contact an

Authorized Service Dealer.

The control cable requires adjustment. SeeAdjust the Auger Control Cable.The snowthrower does not throw snow.

Snow is in the discharge chute. STOP THE ENGINE! Make sure that the auger

STOPS. Use a clean-out tool to remove snow

from the discharge chute. Do not clean a clogged

discharge chute with your hands! SeeCleaning a

Clogged Discharge Chute.

For all other issues, please see an Authorized Service Dealer.