Home
Главная
Vitek
Классические
мультициклон, пылесборник 2.5 л VT-1894 G
Инструкция к Vitek мультициклон VT-1894 G Страница: 4

Vitek мультициклон, пылесборник 2.5 л VT-1894 G Инструкция к Vitek мультициклон VT-1894 G онлайн [4/28] 836967

ENGLISH

close the door if the power cord runs through

the doorway, do not let the power cord come in

contact with sharp edges or corners of furniture.

Do not roll over the power cord with the vacuum

cleaner while room cleaning - it can damage the

cord.

• If the power cord is damaged, it should be

replaced by the manufacturer, a maintenance

service or similar qualified personnel to avoid

danger.

• Do not attempt to repair the unit. Do not disas-

semble the unit by yourself, if any malfunction is

detected or after it was dropped, unplug the unit

and apply to any authorized service center from

the contact address list given in the warranty cer-

tificate and on the website www.vitek.ru.

• Transport the unit in the original package only.

• Keep the unit out of reach of children and dis-

abled persons.

THE UNIT IS INTENDED FOR HOUSEHOLD USE

ONLY, ITS COMMERCIAL USAGE AND USAGE IN

PRODUCTION AREAS AND WORK SPACES IS PRO-

HIBITED.

PRECAUTIONS

• If the suction power of the vacuum cleaner

decreases rapidly while cleaning, switch it off

immediately, remove the power plug from the

socket and check the telescopic pipe and

the flexible hose for obstruction. Remove the

obstruction and only then you can continue

cleaning.

• Do not use the vacuum cleaner near hot sur-

faces, ashtrays and in the places where inflam-

mable liquids are stored.

ASSEMBLING THE VACUUM CLEANER

After unit transportation or storage at low tem-

perature keep it for at least three hours at room

temperature before switching on.

• Unpack the vacuum cleaner completely and

check it for damages. In case of any damages do

not switch the vacuum cleaner on or use it.

• Before switching the vacuum cleaner on for the

first time make sure that your home mains volt-

age corresponds to the vacuum cleaner operat-

ing voltage.

• The unit is intended for operation from an AC

power network with the frequency of 50 or 60 Hz.

The unit does not need any additional settings

for operating with the required rated frequency.

• Always switch the vacuum cleaner off and unplug

it while replacing the brush-attachments and

during maintenance.

Attaching and removing the flexible hose

• Insert the flexible hose ending (8) into the air in-

let (9), matching the ledges on the ending with

the grooves in the air inlet, and turn the ending

clockwise until locking.

• To remove the flexible hose turn the flexible

hose ending (8) counterclockwise and detach

the hose.

Attaching the telescopic pipe

and the brush-attachments

• Attach the telescopic extension pipe (4) to the

handle of the flexible hose (6). Extend the lower

part of the telescopic extension pipe to the re-

quired length, having preliminarily pressed the

button of the lock (3). Choose the necessary at-

tachment - floor/carpet brush (1) or combined

attachment (26) - and attach it to the telescopic

extension pipe (4).

Floor/carpet brush (1)

Set the switch (2) on the brush (1) to the required

position (depending on the type of the surface being

cleaned).

Combined attachment (26)

This attachment is intended not only for cleaning

radiators, crevices, corners and space between

cushions, but also for collecting dust from furniture

surface as well; pile prevents the damage of polished

furniture surface.

Note: Always switch the vacuum cleaner off and

take the power plug out of the socket before

replacing the brush attachments and cleaning the

dust bin (11).

USING THE VACUUM CLEANER

Attention! Always switch the vacuum cleaner

on only with the dust bin (11), inlet filter (20),

outlet HEPA-filter (17) and protective (25) filter

installed. Always check if the dust bin (11) is

assembled properly and the filters (17, 20, 25)

are installed properly.

• Before using the unit, unwind the power cord to

the required length and insert the power plug into

the mains socket. The yellow mark on the power

cord warns about the maximum cord length. Do

not unwind the power cord further than the red

mark.

• Press the on/off button (13) to switch the vacuum

cleaner on.

• During the operation you can control the suc-

tion power using the suction power control (14)

and air flow power control (5) on the flexible hose

handle (6).

VT-1894.indd 4 8/10/20 11:57 AM

Vitek мультициклон, пылесборник 2.5 л VT-1894 G Инструкция к Vitek мультициклон VT-1894 G онлайн [4/28] 836967

Похожие устройства