Ada frozen n rocky grounddrill set 10 grounddrill-10 + frozen gd 250 800 мм + extension 50 А00706 Инструкция по эксплуатации онлайн [6/24] 844495

6 English

lead to the breakage of the gear-wheel of the gear case and the parts of

the engine. Slow down the engine and disconnect it from the auger bit. Set

the pivot of appropriate diameter into the hole of pin – release the auger

bit turning it back.

1. Let engine warm for at least 1 min.

2. Press or release throttle lever to get desired rpms. If the engine reduce

rpms on load, adjust the position of throttle lever.

Important! Do not work without workmate. Otherwise it can lead to the

damages. Avoid running at high rpms for long periods. The unit needs time

for lubricant to get to all internal parts. Do not run the motor at high rpms

without load.

STOPPING

1. Release throttle to idle speed.

2. Turn the ignition switch OFF.

Note: When storing for long periods, remove all fuel from the gas tank. Do

not leave the gas tank at an angle. The pressure inside the tank can cause

the gas to spill out. The gas can spill out on the hot parts of the engine. it

can lead to the ame development.

AIR FILTER

The air lter must be free of dust and dirt to avoid:

1. Carburettor problems

2. Startup problems

3. Reduced engine power

4. Excessive wear of engine parts

5.Abnormal fuel consumption. Clean the air lter daily, or more often

when working in a dusty area.

AIR FILTER CLEANING

Remove the air lter cover and lter.Wash it in warm soap solution. Before

reassembling, check that the lter is dry and not damaged. If the lter has

damages, it’s necessary to replace it. The air lter may not be completely

cleaned when washing and drying. Therefore, it should be regularly re-

placed with a new one.

SPARK PLUG

The condition of the spark plug is aected by: