Timberk N28, 50л. T-WSS50-N28-V Инструкция по эксплуатации онлайн [23/44] 857580

IM2022

Once you have selected the proper site for the water heater, determine the

spots for the holes for fasteners (according to the specifications of the product

you have acquired). Drill two holes in the wall of the appropriate depth using a

drill that is suitable for the size of the fasteners, install the fasteners in the

holes and then hang an electric water heater on it (see Figures 3, 4).

Connecting to the water main

1. The water heater must be connected to the water main with a minimum

pressure of 0.1 MPa and a maximum pressure of 0.7 MPa.

NOTE!

The water heater is a product, in which water pressure corresponds to water

pressure in the water main. If water pressure in the water main exceeds 0.7

MPa, a pressure-reducing valve must be installed before the heater to ensure

that water pressure does not exceed 0.7 MPa.

2. To connect the water heater to the water main, 12 mm (G1/2) diameter

pipes are used.

3. Use rubber seal gaskets on the threaded ends of the pipes in order to

prevent leakage when connecting the pipes.

4. Screw the safety relief valve on the inlet nozzle, which is marked in blue and

has a water flow direction arrow in such a way that that the water flow

coincides with the direction of the arrow on the valve body. Put the water

drainage tube* (water may appear during heating) on the pressure relief port of

the safety relief valve to allow water drainage into the sewer (see Fig. 6) (the

tube must be directed downwards and must not be bent).

5. To facilitate the maintenance of the water heater, it is recommended to

install a drain tap and a tee between the cold water inlet pipe and the safety

valve. This tee will help to drain the water from the water heater faster. For

convenience, it is recommended to connect a water drain hose*to the cut-off

tap of the tee. This hose will allow you to direct the water drained from the

water heater to the sewer or other place of your choice.

6. Connect the required number of water consumption points to the outlet

nozzle marked in red.

7. Open the shut-off valve of the water main and one of the outlet valves.

When the tank is full, which is prompted by water leaking from the outlet valve,

close the outlet valve and make sure that all connectors are tight.

* not included in the scope of delivery. New hoses must be used, old hoses

must not be reused

WARNING!

Do not operate the water heater without a safety relief valve installed on the

inlet nozzle.

WARNING!

The pressure-relief device must be activated on a regular basis to remove the

scale and ensure proper operation.