Bosch GMS 120 Prof 0601081004 Инструкция к товару онлайн [27/455] 860366

English | 27

– In certain conditions (such as behind metal surfaces or behind surfaces with high

water content), live wires cannot always be detected. The signal strength of a live

wire depends on the position of the cable. Therefore, take further measurements in

close proximity or use other information sources to check if a live wire is present.

– You can detect non-live wires as metal objects in the Metal operating mode. Solid-wire

cables are not detected (as opposed to stranded-wire cables).

– Static electricity can cause wires to be detected inaccurately (e.g. over a large area)

or prevent them from being detected at all. To improve the detection, place your free

hand flat on the wall next to the measuring tool, in order to remove the static electri-

city.

Working Advice

Marking objects

If required, detected objects can be marked. Perform a measurement as usual.

Once you have found the boundaries or the centre of an object, mark its position through

the marking hole(2).

Temperature monitoring

The measuring tool features temperature monitoring, as an exact measurement is only

possible as long as the temperature inside the measuring tool remains constant.

If the temperature monitoring indicator(g) lights up, the measuring tool is outside of the

operating temperature range, or has been subjected to large fluctuations in temperature.

Switch the measuring tool off and allow it to adjust to the ambient temperature

switching it back on.

Warning function

If the warning indicator(b) lights up on the display and the operating mode indicator(4)

above the Drywall operating mode button(11) flashes, you must re-start the measure-

ment. Remove the measuring tool from the wall and place it elsewhere on the surface.

If the warning indicator(b) flashes on the display, send the measuring tool in its protect-

ive bag(19) to an authorised Bosch after-sales service centre.

Recalibration

If the measuring indicator(i) indicates a continuously high amplitude in the Metal operat-

ing mode, even though there is no metal object near the measuring tool, the measuring

tool can be manually recalibrated.

– Ensure that the battery indicator(h) still shows a capacity of at least 1/3.

– Switch the measuring tool off.

Bosch Power Tools 1 609 92A 5DB | (23.02.2021)