Hilti SCM 22-A коробка 2041565 Инструкция к товару онлайн [32/256] 861541
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Hilti SCM 22-A коробка 2041565 Инструкция к товару онлайн [32/256] 861541

Hilti SCM 22-A коробка 2041565 Инструкция к товару онлайн [32/256] 861541
26 English 2019522
*2019522*
7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
▶ If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 The circular saw is not in working order.
Malfunction Possible cause Action to be taken
The LEDs indicate nothing. The battery is not fully inserted. ▶ Insert the battery.
The battery is discharged. ▶ Charge the battery.
1 LED blinks. The battery is discharged. ▶ Charge the battery.
The battery is too hot or too cold. ▶ Bring the battery to the correct
ambient temperature.
4 LEDs blink. The circular saw was overloaded
briefly.
▶ Release the control switch and
then press it again.
The overheating prevention cut-out
has been activated.
▶ Allow the circular saw to cool
down to cool down and clean
the air vents.
8.2 The circular saw is in working order.
Trouble or fault Possible cause Action to be taken
The on/off button cannot be
pressed, i.e. the button is
locked.
Not a fault (safety function). ▶ Press the safety lock.
Running speed suddenly
drops considerably.
The saw blade jams. ▶ Do not tilt the saw blade.
Chips / cuttings are not trans-
ported into the chip collector
and thus fall onto the base
plate.
The chip collector is full. ▶ Empty the chip collector.
→ page 24
The chip ejector channel is
blocked.
▶ Clean the ejector. → page 25
The saw blade stalls. Saw advance pressure is too high. ▶ Reduce advance pressure and
switch the product back on.
The battery runs down more
quickly than usual.
Very low ambient temperature. ▶ Allow the battery to warm up
slowly to room temperature.
Printed: 06.06.2019 | Doc-Nr: PUB / 5142664 / 000 / 04

Похожие устройства

Скачать