Home
Главная
Al-Ko
Радиоприемники
WR 2000 EasyFlex 113631
Инструкция к товару Страница: 28

Al-Ko WR 2000 EasyFlex 113631 Инструкция к товару онлайн [28/296] 862009

Al-Ko WR 2000 EasyFlex 113631 Инструкция к товару онлайн [28/296] 862009

GB

28 WR 2000

Commissioning/Decommissioning

■

Handle batteries with care. Improper handling

of the batteries can lead to breakage and es-

cape of electrolyte liquid. This can cause

fires, injuries and contamination of the envi-

ronment.

■

If electrolyte liquid has escaped from the bat-

teries, wipe the battery compartment clean to

avoid further damage.

■

Only use the batteries intended for the appli-

ance.

■

Do not heat or disassemble batteries.

■

Do not throw batteries into fire or water.

■

Always insert batteries in such a way that the

positive and negative poles are correct.

■

Do not insert discharged batteries in the ap-

pliance again.

■

Always insert batteries of the same type.

■

When the appliance is not in operation, re-

move the batteries.

4 COMMISSIONING/

DECOMMISSIONING

4.1 Charging the rechargeable battery

CAUTION!

Danger of fire during charging!

Due to heating of the charger, there is a

danger of fire if it is placed on an inflam-

mable surface and is not adequately ven-

tilated.

■

Always use the charger on a non-in-

flammable surface or in a non-com-

bustible environment.

■

If available: Keep the ventilation slots

free.

NOTE

Heed the separate operating instructions

for the rechargeable battery and for the

charging unit.

NOTE

The battery is not charged and has to be

charged before the tool is used for the

first time.

4.2 Inserting AA batteries and the B50Li

rechargeable battery

Work through the following sections in sequence

to insert the AA batteries and the rechargeable

battery.

4.2.1 Opening the rechargeable battery

cover (03)

1. Pull the locking latch (03/1) upwards (03/a).

2. Push the locking latch forwards (03/b).

3. Fold the rechargeable battery cover (03/2) to

the rear (03/c).

4.2.2 Inserting/removing the two AA

batteries (04)

Two commercially available AA batteries* supply

the station memory with current so that the saved

stations are retained when the B50Li recharge-

able battery is pulled out.

NOTE

Always insert batteries of the same type

and with the same charge status. Insert-

ing different batteries or old and new bat-

teries leads to premature discharging.

Requirements:

■

The rechargeable battery cover is open (see

chapter 4.2.1 "Opening the rechargeable bat-

tery cover (03)", page28).

■

The rechargeable battery has been removed

(see chapter 4.2.3 "Inserting and removing

the B50Li rechargeable battery (05/06)",

page28).

1. Unscrew the screw (04/1) of the battery com-

partment cover (04/2) with a screwdriver*.

2. Remove the battery compartment cover.

3. Insert the two AA batteries (04/3) in the bat-

tery compartment in such a way that the posi-

tive and negative poles are correct

or take the two AA batteries out of the battery

compartment.

4. Insert the battery compartment cover and

screw tight again.

5. Insert the rechargeable battery (see chapter

4.2.3 "Inserting and removing the B50Li re-

chargeable battery (05/06)", page28).

6. Close the rechargeable battery cover (see

chapter 4.2.4 "Closing the rechargeable bat-

tery cover", page29).

*: not included in the scope of supply.

4.2.3 Inserting and removing the B50Li

rechargeable battery (05/06)

Precondition:

■

The rechargeable battery cover is open (see

chapter 4.2.1 "Opening the rechargeable bat-

tery cover (03)", page28).

Похожие устройства