Al-Ko Robolinho 500 E 119833 Инструкция к AL-KO Robolinho 500 E 119833 онлайн [58/476] 868062

Al-Ko Robolinho 500 E 119833 Инструкция к AL-KO Robolinho 500 E 119833 онлайн [58/476] 868062
GB
58 Robolinho 500 E/I | 1150 SE
Help in case of malfunction
Malfunction Cause Remedy
Appliance vibrates or the
volume is too high.
Imbalance on the cutting
blade or in the cutting blade
drive
Clean the mower deck.
Contact an AL-KO service centre.
Rechargeable battery can-
not be charged or low bat-
tery voltage
The charging contacts of
the base station are dirty.
The contact surfaces on
the appliance are soiled.
Clean the charging contacts and contact
surfaces.
Base station has no power. Connect the base station to the power
source.
The appliance does not
touch the charging con-
tacts.
The contact surfaces on
the appliance are burned
out.
Place the appliance in the base sta-
tion and check that the charging
contacts make contact.
Contact an AL-KO service centre.
The service life of the re-
chargeable battery has ex-
pired.
Contact an AL-KO service centre.
The charging electronics are
faulty.
Contact an AL-KO service centre.
NOTE
If you encounter any malfunctions that are not listed in this table or that you cannot rectify
yourself, please contact our customer service.
14.2 Fault codes and troubleshooting
Fault code Cause Remedy
CN001: Tilt sensor The inclination sensor has
been triggered:
Max. tilt exceeded
The appliance has been
carried
Slope too steep
Place the appliance on a flat surface
and acknowledge fault.
CN002: Lift sensor The lift sensor has triggered:
The appliance cover has
been deflected upwards
by lifting or by an obsta-
cle.
Remove the obstacle.
CN005: Bumper de-
flected
The appliance has driven in-
to an obstacle and cannot
free itself (e.g. collision close
to the base station).
Place the appliance on the free,
designated grass surface.
Correct the location of the boundary
cable.

Похожие устройства

Скачать