Home
Главная
Al-Ko
Роботы-газонокосилки
Robolinho 500 E 119833
Инструкция к AL-KO Robolinho 500 E 119833 Страница: 59

Al-Ko Robolinho 500 E 119833 Инструкция к AL-KO Robolinho 500 E 119833 онлайн [59/476] 868062

Al-Ko Robolinho 500 E 119833 Инструкция к AL-KO Robolinho 500 E 119833 онлайн [59/476] 868062

495053_a 59

Help in case of malfunction

Fault code Cause Remedy

CN007: No loop sig-

nal

■

No loop signal

■

The boundary cable is

faulty.

■

Loop signal is too weak.

■

Check the LEDs on the base sta-

tion.

■

Check the power source of the base

station. Disconnect and reconnect

the power supply.

■

Check the boundary cable for dam-

age. Repair the defective cable.

CN008: Loop signal

weak

■

Loop signal too weak

■

Boundary cable buried

too deep

■

Check the LEDs on the base sta-

tion.

■

Check the power source of the base

station. Disconnect and reconnect

the power supply.

■

Raise the boundary cable to the

prescribed height; attach directly on

the grass if necessary.

CN010: Bad position

■

The appliance is outside

the designated grass

surface.

■

The boundary cable has

been routed in a criss-

cross pattern.

■

Place the appliance on the free,

designated grass surface.

■

Correct the location of the boundary

cable around curves and obstacles.

Eliminate the criss-crossing of the

cable.

CN011: Escaped robot The appliance is outside the

designated grass surface.

Correct the location of the boundary ca-

ble around curves and obstacles.

CN012: Cal: no loop

CN015: Cal: outside

Fault during the calibration:

■

The appliance cannot

find the boundary cable.

■

Check the LEDs on the base sta-

tion.

■

Check the power source of the base

station. Disconnect and reconnect

the power supply.

■

Place the appliance at the pre-

scribed calibrating position; align

precisely at right angles. Appliance

must be able to drive over the

boundary cable.

CN017: Cal: signal

weak

Fault during the calibration:

■

Loop signal too weak

■

No loop signal

■

The boundary cable is

faulty.

■

Place the appliance at the pre-

scribed calibrating position; align

precisely at right angles.

■

Check the power source of the base

station. Disconnect and reconnect

the power supply.

■

Check the boundary cable for dam-

age.

CN018: Cal: Colli-

sion

Fault during the calibration:

■

The appliance has

bumped into an obstacle.

Remove the obstacle.

Похожие устройства