Noblelift ACL20 540x1800, PU+PU, tandem 1205401800 Инструкция к товару онлайн [11/20] 869006
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Noblelift ACL20 540x1800, PU+PU, tandem 1205401800 Инструкция к товару онлайн [11/20] 869006

Noblelift ACL35 540x1800mm PU+PU, tandem 1355401800 Инструкция к товару онлайн [11/20] 869013
10
Fig. 6: Axle assembling
Lower
Neutral
Raise
Note: The marked number on the tiller arm package and the chassis
should be the same.
When attaching the handle, you had better squat just in front of the
pallet truck.
a) Insert the tiller arm(1) into the pump piston, then use a hammer to
insert the axle with hole into the hydraulic pump and tiller arm from
the right to the left (Fig. 6 ).
b) Set the control lever of the handle to the ‘LOWER’ position, then pass the adjusting nut,
adjusting bolt through the hole of the axle with
your hand (Fig. 7).
c) Press the tiller arm down; take away the pin
(2, Fig. 5).
d) Set the control lever of the handle to ‘RAISE’
position, then raise the lever plate with the pin
(2, Fig. 5) and insert the adjusting bolt into the
front slot of lever plate. Note: Keep the
adjusting nut under the lever plate.
e) Use a hammer to insert the 2
nd
dowel pin (5,
Fig. 5) into the 2
nd
hole of the axle.
The draw-bar is now assembled to the pump.
b. Hydraulic valve adjustment
On the tiller of your pallet truck, you will find the control lever, which
can be regulated in three positions:
Lower : handle up, the lever moves back to the neutral,
when released
Neutral: handle in center position
Raise: handle down
If necessary, you can adjust the lever according to following steps (Fig. 8):
a) If the forks elevate while pumping in the Neutral position, turn the adjusting nut on the
adjusting bolt clockwise until pumping action does not raise the forks and the Neutral
position works properly.
b) If the forks descend while pumping in the Neutral position, turn the adjusting nut
counter-clockwise until the forks do not lower.
c) If the forks do not descent when the control handle is in the Lower position, turn the
adjusting nut clockwise until raising the control handle lowers the forks. Then check the
Neutral position according to fig. 8 and be sure that the adjusting nut is in the proper
position.
d) If the forks do not elevate while pumping in the Raise position, turn the adjusting nut
counter- clockwise until the forks elevate while pumping in the Raise position. Then check
the Lower and Raise position.
Fig. 7: Side view
Fig. 8: Lever

Похожие устройства

Скачать