Noblelift ACL20 540x1800, PU+PU, tandem 1205401800 Инструкция к товару онлайн [12/20] 869006

c. Foot brake (Optional for some models)

If the truck is ordered with a foot brake, please follow the next instructions. The foot brake might be

already assembled with the truck.

a) Remove the steering wheel (310).

b) Put the Holding sleeve (341) in the under parts of pump

body (322), and take off the parts from (310) one by one.

Fasten the bolt (340) in the fixed hole.

c) Install spring (342), brake plate (344), foot pedal (345)

and (spring) washer (346) on the fixed seat (341) one by

one. Then screw the locknut (347) on the fixed seat (341).

d) Install the grease nipple (343).

d. Progressive- drive- and parking brake (optional for some models)

If the truck is equipped with the progressive drive and parking brake, the braking lever as well

as the bowden cable already assembled to the tiller arm.

a) Turn the pump 90 degree to right side, then pass through the brake cable behind the thrust

plate.(Fig.10)

b) Put the head of the brake cable into the groove of the hinge pin.

c) Then tug the brake cable, let the head of the outer sleeve of the cable into the hole of the

holding pin.

e. Transporting

For transporting, remove the load, lower the truck to the lowest position and lash it safe with

dedicated lashing straps.

f. Storage/ Reassembling

For storage, remove the load, lower the truck to the lowest position, grease all in this handbook

mentioned greasing points (regularly inspection) and eventually protect the truck against

corrosion and dust. Jack the truck safety, so that there will be no flattening after storage.

Reassemble the tiller in the opposite direction of the assembling.

Fig.9 Footbrake

Fig.10: Progressive drive and parking brake