Centek 87 л (26л/61л) 475x495x852 мм (ДхШхВ), 80 Вт GMCC, 2 полки, 42 dB, A+ CT-1704 Инструкция онлайн [27/32] 870471

– Before connecting to the mains, make sure that:

– The mains voltage corresponds to the data indicated on the

special plate on the back of the refrigerator;

– The grounding contact of the electrical outlet is connected to

the grounding wire of the power supply cable of the electrical

network (the connecting wire must be designed for a current

of at least 10 A);

– The socket and plug are of the same type; if the plug does

not fit into the outlet, the outlet should be replaced with the

corresponding plug of the power cord (the work must be

performed by a qualified electrician).

The refrigerator must be installed in such a way that you always

have access to an outlet. A refrigerator connected in violation

of the safety requirements of high-power household appliances

described in this manual is potentially dangerous.

The manufacturer is not responsible for damage to health and

property if it is caused by non-compliance with the specified

installation standards.

5. REFRIGERATOR OPERATION

BEFORE SWITCHING ON

It is necessary to connect the refrigerator to the mains three

hours after its installation. Thus, the refrigerant will be

distributed properly after transportation – this is necessary for

the proper operation of the refrigerator.

A few hours after connecting the refrigerator to the mains, You

can put products in it.

Remove the transport spacers between the compressor and the

back wall of the niche, as well as other spacers and adhesive

tapes that keep the moving parts of the device from shifting.

If the device has a protective coating of polymer film, carefully

remove it, taking precautions not to damage the paint or polymer

coating of the parts.

USING THE COLD STORAGE

The temperature inside the refrigerator compartment is set by

turning the thermostat knob. It is recommended to install the

thermostat in the middle position. The cold air in the refrigerator

compartment circulates in such a way that a lower temperature

is set in the lower part of the compartment. To properly place food

in the compartments to ensure the best storage conditions, follow

the storage instructions: if stored incorrectly, even the freshest

food will quickly deteriorate.

The refrigerator compartment is equipped with convenient

shelves, the height of which can be adjusted using special guides.

This allows you to place large packages and tall bottles on the

shelves. Do not put liquids in containers without a lid in the

refrigerator, in order to avoid an increase in humidity, because

this leads to an increase in temperature in the refrigerator.

USING THE FREEZER

In order to ensure the best storage conditions for products, follow

the recommendations below. Products intended for freezing and

storage in the freezer should be carefully packed to avoid the

formation of excessive frost.

– Preferably, the products placed inside the freezer should not

come into contact with the back and side walls.

– For proper storage and ease of subsequent defrosting, place the

products in small portions.

– Do not place full glass containers with freezing liquids in the

freezer for a long time, especially if

– They contain tightly sealed effervescent or carbonated drinks.

The liquid, crystallizing, can destroy the container.

– Do not put liquids in containers without a lid in the freezer, in

order to avoid an increase in humidity, because this leads to an

increase in temperature.

6. MAINTENANCE AND CARE

To defrost the refrigerator, put the thermostat knob in the «0» and

disconnect the refrigerator from the power supply. At the time of

defrosting, wrap the frozen products in several layers and place

them, if possible, in a cold place. Wash and dry the refrigerator

compartment thoroughly before turning it on again.

If a layer of frost with a thickness of more than 5 mm has

formed in the freezer during operation, it should be prepared for

defrosting. To do this, remove the products from it and place them

on the shelves of the refrigerator. Next, leave the freezer door

open and install any container for collecting melt water, then

wash the freezer and wipe dry.

Always store strong-smelling products in tightly closed

containers to avoid the formation of odors that will be difficult

to remove later.

Wash the inside and outside surfaces of the refrigerator with a

sponge or a soft cloth. Use neutral detergents. Never use powder

abrasive detergents, alkaline compounds, organic acids and hot

water, this can damage the paintwork. Do not use sharp or metal

objects, it may damage the refrigerator.

All removable parts can be washed with a solution of soap or

detergent in water. They can also be washed in the dishwasher.

Remember that all removable parts must be thoroughly dried

before putting them back in the refrigerator.

Dust can accumulate on the refrigerator condenser and interfere

with its normal operation.

Carefully vacuum the back of the refrigerator using suitable

nozzles.

If you are not going to use the refrigerator for a long time,

disconnect it from the power supply, wash it inside, dry it and

leave the doors ajar to avoid the formation of unpleasant odors

and mold.

RECOMMENDATIONS FOR SAVING ELECTRICITY

Install the refrigerator correctly

At a sufficient distance from heat sources,in a well-ventillated

room,in accordance with the recommendations of the

REFRIGERATOR INSTALLATION point.

Set the temperature correctly

Set the thermostat to the middle position. Setting an excessively

low temperature will only affect the increase in electricity

consumption, but will not improve the safety of products.

Do not overfill the refrigerator

Sufficient air circulation is important for the safety of products.

Overfilling with food interferes with free air circulation, proper

operation of the refrigerator and causes additional electricity

consumption.

Keep the door closed

Open the doors only if necessary, remember that each opening of

the door slightly increases the temperature inside the refrigerator

and electricity is consumed to restore the previous temperature.

Make sure that the sealing rubber on the refrigerator doors

remains clean and fits snugly to the case when closed, this will

avoid leakage of cold air.

Centek 87 л (26л/61л) 475x495x852 мм (ДхШхВ), 80 Вт GMCC, 2 полки, 42 dB, A+ CT-1704 Инструкция онлайн [27/32] 870471

Похожие устройства