Hilti NCR 060 II-A22 чемодан 2211686 Инструкция к товару онлайн [13/68] 871378
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Hilti NCR 060 II-A22 чемодан 2211686 Инструкция к товару онлайн [13/68] 871378

Hilti NCR 060 II-A22 чемодан 2211686 Инструкция к товару онлайн [13/68] 871378
*2207110*
2207110 English 9
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 The crimping tool is not in working order.
Malfunction Possible cause Action to be taken
The LEDs on the battery indi-
cate nothing.
The battery is not correctly in-
serted.
▶ Push the battery in until it
engages with a double click.
The battery is discharged. ▶ Change the battery and charge
the empty battery.
The battery is too hot or too cold. ▶ Allow the battery to cool
down or to warm up to room
temperature.
1 LED on the battery blinks. The battery is discharged. ▶ Change the battery and charge
the empty battery.
The battery is too hot or too cold. ▶ Allow the battery to cool
down or to warm up to room
temperature.
4 LEDs on the battery blink. Product momentarily overloaded. ▶ Allow the product to cool down.
Red LED => lights continu-
ously and a warning tone is
emitted.
Technical problem. ▶ Incorrect operation is possible!
Contact Hilti Service.
Red LED => blinks at short
intervals and a warning tone
is emitted.
The state of charge of the battery
is too low to allow a complete op-
erating cycle.
▶ Change the battery and charge
the empty battery.
Red LED => lights briefly and
no warning tone is emitted.
Product overheated. ▶ Allow the product to cool down.
8.2 The crimping tool is in working order.
Trouble or fault Possible cause Action to be taken
The battery runs down more
quickly than usual.
Very low ambient temperature. ▶ Allow the battery to warm up
slowly to room temperature.
The battery does not engage
with an audible double click.
The retaining lugs on the battery
are dirty.
▶ Clean the retaining lugs and refit
the battery.
Red LED => blinks at long
intervals and a warning tone
is emitted.
Crimping pressure not achieved
(tool was used incorrectly).
▶ Make sure that the tool is used
correctly and check the crimped
/ pressed part if unsure.
Red LED => lights continu-
ously and a warning tone is
emitted.
Technical problem. ▶ Incorrect operation is possible!
Contact Hilti Service.

Похожие устройства

Скачать