Hilti NCR 120 PC-A22 чемодан 2235820 Инструкция к товару онлайн [11/64] 871379

*2215656*

2215656 English 7

5 Operation

5.1 Preparations at the workplace

CAUTION

Risk of injury by inadvertent starting!

▶ Before inserting the battery, make sure that the product is switched off.

▶ Remove the battery before making any adjustments to the power tool or before changing accessories.

Observe the safety instructions and warnings in this documentation and on the product.

5.2 Charging the battery

1. Before charging the battery, read the operating instructions for the charger.

2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.

3. Use an approved charger to charge the battery.

5.3 Inserting the battery

CAUTION

Risk of injury by short circuit or falling battery!

▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product

are free of foreign matter.

▶ Make sure that the battery always engages correctly.

1. Charge the battery fully before using it for the first time.

2. Push the battery into the battery holder until it engages with an audible click.

3. Check that the battery is seated securely.

5.4 Removing the battery

1. Press the battery release buttons.

2. Remove the battery from the tool.

5.5 Fitting the crimping / pressing die 2

WARNING

Risk of injury! Unintentional starting.

▶ Remove the battery before inserting, changing or removing the crimping die.

Never operate the product without a crimping die installed.

1. Remove the battery and select the most suitable crimping / pressing die.

2. Push the crimping / pressing dies in until they engage.

3. Rotate the crimping / pressing head to the desired working position.

The crimping / pressing head can be rotated much more easily when not under pressure.

5.6 Removing the crimping die 3

WARNING

Risk of injury! Unintentional starting.

▶ Remove the battery before inserting, changing or removing the crimping die.

1. Remove the battery and rotate the crimping / pressing head into the outset position.

2. Press the lockbuttons and remove the crimping / pressing dies.