Sven Pro 1000 USB SV-013868 [21/28] Power supply

ENG

1. PRECAUTIONS

Before operating this device, please carefully read the following safety instructions:

• Before switching on the Uninterruptible Power Supply (UPS) in the electric mains for the ﬁrst time,

it is necessary to charge the storage battery for at least 12 hours. For this purpose the UPS should

be switched on without load in the electric mains.

• If the storage battery has fully run down or the UPS has not been operated for three months, it is

also necessary to charge the storage battery for at least 12 hours. Otherwise, its durability will be

considerably reduced.

• The battery warranty (included into the UPS) is 6 months from the sale date (but not more than

18 months from the UPS manufacture date).

• The UPS is designed solely for operation with PCs equipped with switching power supply units*.

• Do not installed the stabilizer in a place with insuﬃcient ventilation. The minimum air gap is of 25 cm.

• During operation, the case of the device can be heated up to 50°C, which is absolutely normal.

• It is strongly forbidden to open case of the device, as there is high voltage inside. If some prob-

lems occur, please address an authorized service centre. For the list of authorized service centres

please go to www.sven.ﬁ.

• Do not let liquid and foreign objects get inside the device, it can cause short circuit, get out

down the device or electric shock.

• In case there are signs of improper operation of the device (sparkling, unusual smells, etc.), it is

necessary to turn oﬀ the device immediately and disconnect it from the mains, and address your

nearest authorized service centre.

• It is forbidden to connect the UPS to equipment with power consumption higher than

its maximum output power. It can cause overload and breakdown of the device.

It is strongly forbidden to operate the device in following conditions:

• in dusty environment or environment containing highly inﬂammable gas;

• at temperature higher than 40°C or lower than 0°C;

• at relative humidity level higher than 90%;

• in direct sunlight or next to heating elements;

• in vibration places;

• outdoors.

• In case of ﬁre use only powder ﬁre extinguisher, as using water can cause electric shock.

• Try to install the UPS in proximity to power supply, in such way it will be easier to unplug the device

if necessary.

*The device operation is not guaranteed when connecting UPS to equipment with APFC (active

power factor correction).

Uninterruptible

Power Supply