Dreame Cordless Vacuum Cleaner Z20 Руководство по эксплуатации онлайн [21/165] 881339
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Dreame Cordless Vacuum Cleaner Z20 Руководство по эксплуатации онлайн [21/165] 881339

Dreame Cordless Vacuum Cleaner Z20 Руководство по эксплуатации онлайн [21/165] 881339
7
EN
Replacing the Battery Pack
The vacuum contains a removable rechargeable lithium-ion battery pack which has a
limited number of recharge cycles. After extended use, the battery pack may no longer
hold a charge. If this happens, it means the battery pack has reached the end of its life
cycle and needs to be replaced.
1.
Press down the battery pack release button and slide the battery pack to the right, as
illustrated, to remove it.
2.
Install the new battery pack.
FAQ
If the vacuum is not working properly, please refer to the table below.
Errors Possible Causes Solutions
The vacuum does
not work.
The appliance is out of battery or its
battery level is low.
Fully charge the vacuum, then resume
use.
Overheat protection mode triggered
by a blockage.
Clean the suction opening or air duct.
Wait until the vacuum cools down, then
reactivate it.
The suction opening or air duct is
blocked.
Clear any blockage from the suction
opening or air duct.
Weak suction force.
The dust cup is full and/or 󶀄lter
assembly is clogged.
Empty the dust cup and/or clean the
󶀄lter assembly.
An attachment is blocked. Clear any blockage in the attachment.
The motor makes a
strange noise.
Main suction opening or extension
rod is blocked.
Clear any blockage in the main suction
opening or extension rod.
The battery
indicator does
not light up when
charging.
The charger does not plug into the
vacuum well.
Check whether the charger is properly
plugged into the vacuum.
The battery is charged and switches
to Sleep Mode automatically.
The vacuum runs normally.
If the problem persists after ruling out the above two possibilities, please
contact the after-sales service department for maintenance.
Charging too slow.
The battery temperature is too low or
too high.
Wait until the battery temperature
returns normal, and then recharge.
The LED light of the
illumination omni-
brush does not
work.
The LED light is damaged.
Please contact the after-sales
department for maintenance.

Похожие устройства

Скачать