Denzel ID-1050-2, 1050 Вт, 2 скорости (26312) Руководство по эксплуатации онлайн [8/28] 886424

ELECTRIC IMPACT DRILL

Description

Electric handheld drill machine (drill) is a rotary machine consisting of electric drive and gearbox, on the output

shaft of which the possibility of fixing the rig with the help of a three-cam self-centering chuck is provided.

The actuator is an AC collector motor housed in a plastic housing. Engine control is carried out using the trigger

switch with built-in motor speed control. It is possible to switch the direction of rotation of the spindle to use

dierent tooling.

The machine is equipped with an impact function implemented by using two crowns, providing a reciprocating

movement of the spindle during rotation. This feature increases the eciency of the machine when drilling hard

and brittle materials (brick, concrete, etc.).

The machine is equipped with a side handle that allows you to hold the tool with two hands, providing

convenience when working.

OPERATION

ATTENTION!

Always disconnect the power cable from the electrical outlet before preparing for the opera-

tion, adjustment, maintenance of power tools.

Installing the side handle

ATTENTION!

Always use the additional handle supplied with the machine. Losing control of the machine can

cause injury.

ATTENTION!

Before work, always check the reliability of the side handle.

Turn side handle 11 (pic. 1) counterclockwise relatively to securing collar by 2..3 turns to loosen it.

Install the side handle on the neck of the machine body behind the chuck. In this case, the chuck 1 (pic. 1)

is not an obstacle to the installation of the handle, if necessary, rotate the side handle another 1..2 turns.

Set the handle to a position that is convenient for operation and tighten the clamp by turning the handle clockwise.

Installation/ withdrawal of the working tool

ATTENTION!

When installing, removing, replacing the tooling, disconnect the power plug. Accidental

switching on of the machine when changing accessories may cause signicant injury.

Open the chuck by rotating its outer sleeve counterclockwise until the chuck’s cams spread over a distance

sucient to install shank snap. If the chuck is tightened, use the key supplied with the machine.

Install shank snap into the chuck. Use tooling with round or hex shank. Never use a snap with an SDS-plus shank,

designed for rotary hammers, this shank cannot be centered properly in the three-jaw chuck.

Close the chuck by turning the outer sleeve clockwise by hand. Make sure the cams converge evenly and center

the tool shank. Tighten the chuck with the supplied key.

ATTENTION!

In order to avoid damage to the engine of the machine and injury, do not tighten or open

the drill chuck, turning on the engine while holding the outer sleeve of the chuck with the hand.