Buffalo LS-WSX2.0TLR1WHE [20/92] Power mode switch

Auto: LinkStation automatically turns o when computers with NAS Navigator2 installed

turn o. The LinkStation automatically powers on when any of the computers on the net

work power on. (The LinkStation uses very low power consumption using this feature)

On: The LinkStation stays on, even when computers are o.

O: Turns LinkStation o. (Factory default)

Note: – Damage can occur to the LinkStation if the AC adapter is removed while in the ON posi-

tion.

– Some environment may not recognize “AUTO” or this unit may not synchronize with the

computer’s power behavior. When this occurs, switch it to “ON”.

– It may take a while until the Power LED turns o after you turn o your computer.

– Set the Power switch to “ON” position when you set up the LinkStation. Otherwise (or

when it is set to “AUTO”), the LinkStation may shutdown during the setup. After the ini-

tial setup, switch it to “AUTO” to synchronize with the power of your computer.

– If the LinkStation is off while using the power linking feature with PC due to a power

outage or AC adapter is removed, switch the Power switch to ON and boot LinkStation.

Put the Power Switch back to the “AUTO” position after LinkStation boot up, enabling

the power linking feature with PC.

– Keep in mind that immediately after the Power switch is switched to the “ON” or “AUTO”

position, the LinkStation will not shut down for about 5 minutes while it checks the sta-

tus of your computer.

– The LS-WXL and LS-WSXL don’t automatically shut down during RAID initialization or

rebuild. If the attached personal computer is shut down during RAID initialization or

rebuild, the LinkStation will complete the RAID initialization or rebuild before shutting

down.

LS-XHL, CHL LS-WXL LS-WSXL

Chapter2 Using your LinkStation

LinkStation Setup Manual

1919

Power Mode Switch

The LinkStation automatically turns ON or OFF with your computer. Install NAS Navigator2 on a

computer and set “Auto Power Management feature”.