Buffalo TS-6VH6.0TL/R6EU [64/75] Accessing from a nfs client

Accessing from a NFS Client

Use the following procedure congure the TeraStation for access from UNIX with NFS.

Note: This section is for information only. Unix and NFS are not supported by Bualo. If you choose to congure your

TeraStation this way, it does not void your warranty, but you are on your own for tech support.

1 In the Web Admin interface, select [Network] - [NFS] - [NFS Service], and click [Modify Settings].

Note:

• If you use a public folder of the TeraStation set by NFS as a hard drive for VMware ESX/ESXi, it is required to set

[NFS Mode] to [Kernel mode] in order to use it (It is set to [User mode] by default).

• To set access restrictions by IP addresses, specify a [Network Address] and [Subnet Mask] from the screen

above.

(e.g.) To allow access from a client with the IP address 192.168.11.xxx:

[Network Address]: 192.168.11.0

[Subnet Mask]: 255.255.255.0

xxx can be 1 to 254. Enter 0 (zero) for the [Network Address].

(e.g.) To allow access from a client with the IP address 192.168.xxx.xxx:

[Network Address]: 192.168.0.0

[Subnet Mask]: 255.255.0.0

xxx can be 1 to 254. Enter 0 (zero) for the [Network Address]

3 Click [NFS Folders Setup].

1 Click [Enable].

2 Click [Save].

1 Write down the NFS public path.

2 Click [Enable].

3 Click [Save].

Choose a shared folder.