Vitek VT-8329 Руководство по эксплуатации онлайн [10/36] 811773
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Vitek VT-8329 Руководство по эксплуатации онлайн [10/36] 811773

Vitek VT-8329 Руководство по эксплуатации онлайн [10/36] 811773
10
ENGLISH
•
This unit is not intended for usage by children.
Place the unit out of reach of children during
operation and cooling down.
•
The unit is not intended to be used by peo-
ple with physical, sensory or mental disabilities
(including children) or by persons lacking expe-
rience or knowledge if they are not under super-
vision of a person who is responsible for their
safety or if they are not instructed by this person
on the usage of the unit.
•
Do not use the unit if the power cord or the
power plug is damaged. If the power cord is
damaged, it should be replaced by the manu-
facturer, service or similar qualified personnel
to avoid danger.
•
Do not use the iron after it was dropped, if there
is visible evidence of damage or if the iron is
leaking.
•
Do not attempt to repair the unit. Do not dis-
assemble the unit by yourself, if any malfunc-
tion is detected or after it was dropped, unplug
the unit and apply to any authorized service
center from the contact address list given in
the warranty certificate and on the website
www.vitek.ru.
•
Transport the unit in the original package only.
•
Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY. ITS COMMERCIAL USAGE AND USAGE IN
PRODUCTION AREAS AND WORK SPACES IS
PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage at low tem-
perature keep it for at least three hours at room
temperature before switching on.
•
Unpack the iron; remove the protection from the
soleplate (13), if any.
•
Check the unit for damages, do not use the iron
in case of damages.
•
Before switching the iron on, make sure that
your home mains voltage corresponds to the
iron operating voltage.
•
The unit is intended for operation with AC system
and 50 or 60 Hz frequency. The unit does not
need any additional settings for operating with
the required nominal frequency.
•
There may be water residue in the tank, this is
normal, as the iron has undergone factory qual-
ity control.
Note: While the first switching on the heating ele-
ment of the iron burns, therefore occurrence of
foreign smell and a small amount of smoke is pos-
sible, it is normal.
Control knobs, indications and symbols
•
Steam supply mode switch (3) has 4 positions:
– – maximal steam supply;
– ЕСО –optimal steam supply;
– – steam supply is switched off;
and one unfixed position:
– CALС CLEAN – self-cleaning.
•
Burst of steam button (4) – press the button to
activate the additional steam supply function.
•
Water spray button (5) – press the button to acti-
vate the water spray function.
•
Heating element ON/OFF indicator (7) – when
the indicator lights up, the iron soleplate is
heating up.
•
Temperature control knob (11) – allows to set
the iron soleplate temperature depending on the
type of fabric (see the table below). The knob is
in the position «MIN» – the iron is off.
•
Maximum water level indicator «MAX» (12).
•
The symbol indicates hot surfaces.
WATER SELECTION
You can use tap water to fill the water tank (10).
If tap water is hard, use distilled or demineralized
water, this will prolong service life of the iron.
Note: Do not fill the water tank (10) with scented liq-
uids, vinegar, starch solution, descaling reagents,
chemical agents etc.
FILLING THE WATER TANK
Before filling the iron with water, make sure that it
is unplugged.
•
Set the temperature control knob (11) to the
position «MIN», and turn the steam supply
mode switch (3) to the position – steam
supply is off.
•
Open the water inlet lid (2).
•
Open the lid (2) and pour water into the water
tank (10) using the beaker (14) and then close
the lid (2) tight.
Note:
•
Do not exceed the «MAX» mark (12).
•
If you need to refill water during ironing, always
switch the iron off first and unplug it.
•
After you finish ironing, switch the iron off, wait
until it cools down completely, then open the
water inlet lid (2), turn over the iron and drain the
remaining water.

Похожие устройства

Скачать