Home
Главная
Brayer
Термопот
BR6002
Инструкция по эксплуатации Страница: 10

Brayer BR6002 Инструкция по эксплуатации онлайн [10/44] 904101

• By pressing the button (14) « », set the water

supply volume: 200 ml, the set water supply volume

will be displayed in digital symbols (19).

• Press the button (16) «

» to set the water

supply temperature: 100°C, the set water supply

temperature will be displayed with digital symbols

(20).

• To turn on the water supply, press the button (13) «

», after 5-10 seconds the water will ow out of the

spout (3), if you need to turn o󰀨 the water supply,

press the button (13) «

» again.

• After lling the cup with hot water for the rst time,

drain the water and ll and drain the hot water from

the cup one or two more times.

ATTENTION! Be careful when pouring out water to

avoid burns by hot water.

• It is not recommended to consume the hot water

obtained from the initial boiling for food, you can use

it for household needs.

USING THE THERMOPOT

• Place the thermopot on a dry at surface keeping at

least 20 cm gap between the thermopot body and

the wall or furniture and at least 50 cm gap above the

thermopot.

• Fill the thermopot with water using suitable

containers, but do not exceed the maximum water

level mark. Do not ll the thermopot with water

directly from the faucet; to ll the thermopot use a

suitable bowl.

• You can remove the water tank (6) and ll it with

water (Fig. 2), replace the tank (6) and close it with

the lid (5).

• Insert the power cord plug into the mains socket.

• Place a cup of the required volume onto the grid (2)

of the removable drip tray (1), make sure that the cup

is under the water drain spout (3).

• To unlock the thermopot, press and hold the «

button (17) for approximately 3-5 seconds.

• Press the button (14) «

» to set the desired water

supply volume: 100 ml, 200 ml, 300 ml, 400 ml,

000 (continuous water supply), the set water supply

volume will be displayed with digital symbols (19).

• • Press the button (16) «

» to set the desired water

supply temperature: 45°C, 55°C, 65°C, 75°C, 85°C,

100°C, 000 (normal temperature water), the set water

supply temperature will be displayed with digital

symbols (20).

• To turn on the water supply, press the button (13) «

», after 5-10 seconds the water will ow out of the

spout (3), if you need to turn o󰀨 the water supply,

press the button (13) «

» again.

Note: in the water supply mode for preparing baby food,

water is supplied by pressing and holding the button

(18) «

», when you pour the required amount of water,

release the button (18) «

».

Brayer BR6002 Инструкция по эксплуатации онлайн [10/44] 904101

Похожие устройства