Home
Главная
Brayer
Термопот
BR6002
Инструкция по эксплуатации Страница: 11

Brayer BR6002 Инструкция по эксплуатации онлайн [11/44] 904101

the settings will be reset and you will need to re-

enter the desired water temperature and volume.

CALIBRATION

• If you nd that the water temperature and volume are

not accurate enough, follow these steps:

1. Fill the water tank (6) to the maximum level.

2. Place a container under the water drain spout (3)

into which you can collect all the water from the

tank (6) (at least 3 liters). To make it easier to install

the container, you can remove the drip tray (1).

Plug the power cord into an electrical outlet.

3. Press and hold the button (16) «

» for 3 seconds,

«AUT» will be displayed in symbols (120), «000»

will be displayed in symbols (19) (continuous water

supply).

4. Press the on/o󰀨/water supply button (13) «

» to

conrm.

5. The thermopot will enter calibration mode and

automatically exit after completion.

• The calibration mode time is about 4-5 minutes.

During calibration, water will be supplied to the

installed container (at least 3 liters).

«RESET» BUTTON

• If an emergency situation occurs and the heating

element overheats, the thermal switch will be on and

the thermopot will be switched o󰀨.

• Unplug the power cord from the mains socket, let the

thermopot cool down for 20-30 minutes.

WARNING! To avoid the risk of burns, always check

the temperature of baby food before giving it to

your baby. You can easily check the temperature

of baby food by placing a few drops on the back of

your hand.

ATTENTION! Be careful when pouring water into the

cup to avoid burns by hot water.

• If the tank (6) runs out of water, you will hear a sound

signal, the ashing error code «Е 7» and the ashing

indicator (11) « » are displayed, add water to the tank

(6) and continue using the unit.

Notes:

- the water temperature in the water tank (6) is

displayed with digital symbols (21),

- if you pour a small amount of water, in this case

the temperature may

- di󰀨er slightly from the digital temperature readings

(20). In this case, if the dishes are cold and the

set water temperature is low, it is recommended

to preheat the dishes into which the water will be

supplied;

- The ambient temperature may change periodically,

which may lead to a slight inaccuracy in the water

supply. The volume of water supplied may di󰀨er up

to + - 15% of the digital readings (19);

- the thermopot has a memory function if the power

cord plug is inserted into an electrical outlet. If you

unplug the power cord from the electrical outlet,

Brayer BR6002 Инструкция по эксплуатации онлайн [11/44] 904101

Похожие устройства