Home
Главная
Brayer
Термопот
BR6002
Инструкция по эксплуатации Страница: 12

Brayer BR6002 Инструкция по эксплуатации онлайн [12/44] 904101

• Insert, for example, a wooden toothpick into the hole

of the reset button (8), and press it slightly until the

thermal switch is switched on with a distinctive click.

• Plug the power cord into the mains socket, switch the

thermopot on and check its operation.

• If the thermopot is not swtiched on, this may

indicate another malfunction, in which case contact

the service center for inspection or repair of the

thermopot.

CLEANING AND MAINTENANCE

• Unplug the thermopot before cleaning.

• Clean the outer surface of the thermopot body with a

slightly damp cloth and then wipe it dry.

• Use neutral detergents to remove dirt, do not use

metal brushes, abrasives and solvents.

• Do not immerse the thermopot and the power cord

into water or other liquids.

• Do not put the thermopot in a dishwashing machine.

Removing the mineral deposits (descaling)

• After using the thermopot for 10 hours, the «

indicator (10) will ash, reminding you to descale.

• Scale, appearing inside the thermopot heater,

inuences the water taste and disturbs the heat

exchange between water and the heating element. It

also risks damaging the heating element. Burning of

the heating element caused by the large amount of

scale is not covered by warranty.

• To remove the scale ll the water tank (6) with a

mixture of one part ordinary vinegar and two parts

water up to the maximum water level.

• Insert the power cord plug into the mains socket.

• Place a container under the water drain spout (3)

into which you can collect all the water from the tank

(6) (at least 3 liters). To make it easier to install the

container, you can remove the drip tray (1).

• Press and hold the button (15) «

» for 3 seconds,

the descaling function will turn on and the cleaning

solution will be supplied to the installed container.

Once all the cleaning solution has exited the tank (6),

cleaning of mineral deposits is completed and the «

» indicator (10) will stop ashing.

• When the removal of mineral scale is complete,

unplug the unit and wait for some time for the water

in the heating element of the thermopot to cool down.

• Remove the water tank (6).

• Lift the tray (1) and remove it.

• Place the thermopot, for example, over the kitchen

sink and unscrew the drain plug (9) by turning it

counterclockwise.

• Wait until the remaining cleaning solution has drained

away, install the plug (9) to its place and thread it

rotating clockwise until it stops.

Note: if you notice water drops under the thermopot,

screw the plug (9) more tightly.

• Install the thermopot and ll the water tank (6) with

clean water to remove any remaining cleaning

solution.

Brayer BR6002 Инструкция по эксплуатации онлайн [12/44] 904101

Похожие устройства