Home
Главная
Brayer
Фен-Щетка
BR3137
Инструкция по эксплуатации Страница: 6

Brayer BR3137 Инструкция по эксплуатации онлайн [6/32] 904119

• Wipe the unit with a clean, slightly damp cloth to

remove dust, and then wipe it dry.

• Unwind the power cord to its full length while using

the unit.

USING THE HOT AIR STYLER

• The hot air styler is intended for household use only.

• To achieve good results, wash your hair with a

shampoo, wipe with a dry towel, dry with a hairdryer

and comb it, after that you can begin styling your hair.

• Unwind the power cord at full length.

• Install one of the nozzles (1, 6 or 7), insert the nozzle

(1, 6, 7) into the body of the hot hair styler and turn it

towards the «

» symbol. Make sure that the installed

nozzle is xed properly.

• Set the operation mode switch (3) to the position «0».

• Insert the power plug into the mains socket.

• Use the switch (3) to set the desired operating mode:

- «0» — the hairdryer is o󰀨,

- «

» — «cool» air supply,

- «1» — low temperature;

- «2» — high temperature;

• When using the thermo brush (1, 6) you can change

the thermo brush rotation direction with the buttons

(2). During the operation press and hold down the

button (2), the thermo brush (1, 6) will rotate in the

required direction.

Note: during the rst operation a foreign smell and a

small amount of smoke can appear from the heating

element, this is normal and it is not covered by warranty.

• Divide the hair into locks.

• Use the operation mode switch (3) to set the required

operation mode.

• Wind a hair lock around the installed thermo brush

(1, 6), select the brush rotation direction with the

buttons (2). When the hair lock is wound around the

brush, release the button (2) and the rotation of the

thermal brush will stop.

• Depending on your hair type, select the necessary

operation mode with the switch (3).

• To x the lock set the operation mode switch (3) to

the position «

» — cool shot.

• Switch the hot air styler o󰀨 by setting the operation

mode switch (3) to the position «0».

• Take the thermo brush out of the hair.

Notes:

- if it is di󰀩cult to remove the thermal brush (1, 6)

from the hair, turn the unit o󰀨 by setting the switch

(3) to «0», turn the thermal brush (1, 6) to «

»,

remove the thermal brush (1, 6) from the unit body

and carefully remove it from the lock of hair.

- avoid contact of the hot surface of the thermal

brush (1, 6) with face, neck and other parts of the

body during operation.

• After nishing work, set the switch (3) to the «0»

position and unplug the power cord from the

electrical outlet.

• Wait for the thermal brush to cool down.

• Remove the thermal brush (1, 6) by turning the

thermal brush (1, 6) to the «

» position and pulling it

out of the unit body.

Brayer BR3137 Инструкция по эксплуатации онлайн [6/32] 904119

Похожие устройства