Magnit RMZ-3403 [5/18] Blade alignment

Содержание

• Страница 1 1
• Ф mrgnit 1
• Страница 2 2
• Description 3
• Страница 3 3
• Important safeguards 4
• Note keepthe blades oiled 4
• Страница 4 4
• Blade alignment 5
• Instructions for hair cutting 5
• Страница 5 5
• Care and cleaning 6
• Detachable combs 6
• Storage 6
• Страница 6 6
• Страница 7 7
• Корпус 8
• Ножи 8
• Описание 8
• Рычаг управления ножами 8
• Страница 8 8
• Страница 9 9
• Внимание регулярно смазывайте лезвия 10
• Длина срезаемых волос 10
• Регулировка лезвий 10
• Смазка лезвий 10
• Страница 10 10
• Очистка 11
• Подготовка к работе 11
• Страница 11 11
• Съемные гребни 11
• Хранение 11
• Страница 12 12
• Страница 13 13
• Гарантийный срок на данное изделия составляет 14
• Гарантийный срок не предоставляется на расходные части изделия 14
• Гарантийный талон 14
• Месяцев 14
• Страница 14 14
• ____________________________________________________ м п 15
• Пон 5 15
• Страница 15 15
• Страница 16 16
• Адреса сервисных центров 17
• Страница 17 17
• Страница 18 18

Похожие устройства

• Delonghi Pixie Clips EN 126 Инструкция по эксплуатации
• Voxtel ELEGANT 105 Инструкция по эксплуатации
• Magnit RMZ-3404 Инструкция по эксплуатации
• Hyundai H-DVR16HD Инструкция по эксплуатации
• Magnit RMZ-3410 Инструкция по эксплуатации
• Voxtel ELEGANT 100 Инструкция по эксплуатации
• Canon IXUS 160 Red Инструкция по эксплуатации
• Voxtel WALL 1910 Инструкция по эксплуатации
• Magnit EPS-1010 Инструкция по эксплуатации
• Voxtel CONCEPT COMBO 7210 Инструкция по эксплуатации
• Candy GrandO Extra GC4 1061D-07 Инструкция по эксплуатации
• Magnit EPS-1011 Инструкция по эксплуатации
• Voxtel PROFI 5100 TWIN Инструкция по эксплуатации
• Nikon Coolpix L31 Black Инструкция по эксплуатации
• Magnit EPS-1020 Инструкция по эксплуатации
• Voxtel SYMPHONY 115 Инструкция по эксплуатации
• Ritmix RF-4850 8Gb Mint Инструкция по эксплуатации
• Magnit EPS-1021 Инструкция по эксплуатации
• Voxtel SYMPHONY 105 Инструкция по эксплуатации
• Philips 55PFS8159/60 Инструкция по эксплуатации

BLADE ALIGNMENT Your clipper was carefully examined to ensure that the blades were oiled and properly aligned before leaving our factory Blades must be realigned if they were removed for cleaning or after replacement To realign the blades simply match the upper and lower blades teeth up point for point End of top blade teeth should be approximately 1 2 mm back from lower blade Compare your clipper blades with the sketch pic 1 If blade alignment is incorrect add a few drops of oil to the blades switch on the clipper for a few moments switch off and unplug Loosen screws slightly and adjust Tighten screws after blade is aligned OILING To maintain your clipper in peak condition the blades should be oiled after every haircut Do not use hair oil grease oil mixed with kerosene or any solvent BLADE LEVER The lever located to the left of the blades allows easily adjust cut hair length while clipping The lever adds versatility to your clipper by allowing you gradually change the closeness of your cut without an attachment comb When the lever is in the uppermost position the blades will give you the closest cut and leave the hair very short Pushing the lever downwards gradually increases the cutting length In its lowest position the lever will leave the hair approximately the same length as a 1 3mm comb The lever will also extend the use of your blades since a different cutting edge is used in each setting In addition if extremely heavy hair cutting has jammed the blades it will help you to remove hair that has become wedged between the two blades without removing the blades While the clipper is running rapidly move the lever from close cut to longer cut a couple of times Do this each time after you have finished using your clipper to keep the blades free of cut hair If this does not help and clipper stops cutting blades are dulled Replace them with new blades INSTRUCTIONS FOR HAIR CUTTING Before starting the hair cut inspect the clipper making sure that there is no oil between the cutting blade teeth switch the unit on to distribute the oil between the blade teeth and to check running smoothness Wipe off any excess oil This should be done after each use While using the unit untwist the cord from time to time to avoid tangling Before cutting always comb the hair thorough Close cut 5