Home
Главная
Sea-Doo
Гидроцикл
GTX Limited iS 2009
Инструкция по эксплуатации Страница: 113

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [113/555] 12053

Section 02 ENGINE

Subsection 08 (LUBRICATION SYSTEM)

GENERAL

During assembly/installation, use torque values

and service products as in the exploded views.

Clean threads

before applying a threadlocker. Re-

fer to

SELF-LO

CKING FASTENERS

and

LOCTITE

APPLICATION

t the beginning of this manual for

complete proc

edure.

WARNING

Torque wrench tightening specifications

must be strictly adhered to.

Locking devices (e.g.: locking tabs, elastic

stop nuts, self-locking fasteners, cotter pins,

etc.) must be replaced with new ones.

Hoses, cables or locking ties removed during a

procedure must be reinstalled as per factory stan-

dards.

MAINTENANCE

ENGINE OIL

Recommended Oil

Use XPS SUMMER GRADE OIL (P/N 293 600 121).

If XPS

engine oil is not available, use a 10W40

mineral engine oil compatible with wet clutches.

NOTE: The XPS engine oil has been thoroughly

tested to be free of any additives that could impair

the functionality of the supercharger clutch.

NOTICE

NEVER use synthetic oil. This would

impair the proper operation of the super-

charger clutch. Do not add any additives to

the recommended oil. Mineral oils not recom-

mended by BRP may also contain additives

(friction modifiers) that may cause inappropri-

ate slippage of the supercharger and eventu-

ally lead to premature wear. For this reason,

XPS Summer Grade oil or a BRP approved

equivalent are the only recommended oils.

Use of any oil not recommended by BRP may

void BRP's limited warranty.

Oil Level Verification

NOTICE

Check level frequently and refill if

necessary. Do not overfill — it would make

the engine smoke and reduce its power. Op-

erating the engine with an improper level

may severely damage engine. Wipe off any

spillage.

smo2009-002-003_b

1. Oil dipstick

Check the oil level as follows:

NOTE: It is of the utmost importance to follow

this procedure in order to obtain an accurate read-

ing of the engine oil level.

1. Watercraft must be level. Check oil level either

with watercraft in water or out of water.

2. If the watercraft is out of water, link a garden

hose to the hose adapter. Refer to

EXHAUST

SYSTEM FLUSHING

in the

EXHAUST SYSTEM

subsection.

NOTICE

When watercraft is out of water:

– Never run engine without supplying water to

the exhaust system.

– Never run engine longer than 2 minutes.

Drive line seal has no cooling when water-

craft is out of water.

3. Warm-up engine then let idle for 30 seconds

before stopping.

4. Stop engine.

5. Open seat and remove the ventilation box from

the deck extension to gain partial access to en-

gine compartment.

NOTE: To remove the rear ventilation box, simply

release the 3 clips retaining it and lift it off the deck

extension.

90 smr2009-023

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [113/555] 12053

Похожие устройства