Home
Главная
Sea-Doo
Гидроцикл
GTX Limited iS 2009
Инструкция по эксплуатации Страница: 120

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [120/555] 12053

Section 02 ENGINE

Subsection 08 (LUBRICATION SYSTEM)

R1503motr118A

1. Oil inlet to the oil pump

PTO Oil Strainer Installation

For installation, reverse the removal procedure.

However, pay attention to the following.

Clean cylinder block to remove all remaining sili-

cone residues in oil strainer area.

Apply a thin layer of

LOCTITE 5910 (P/N 293 800 081)

on oil strainer side.

Install it in the PTO housing.

Install the PTO housing using the procedure de-

scribed in the

PTO HOUSING AND MAGNETO

subsection.

Refill engine at the proper level with the recom-

mended oil. Refer to

ENGINE OIL

for the proce-

dure.

SUCTION PUMP OIL STRAINER

NOTE: The oil strainer does not need to be

cleaned at every oil change. Clean it during other

inspections, especially when the engine is disas-

sembled.

Suction Pump Oil Strainer Removal

Remove oil filler tube and suction pump cover, re-

fer to

OIL SUCTION PUMP

in this subsection.

Remove oil strainer from the suction pump cover.

smr2006-014-022_a

1. Oil strainer

2. Suction pump cover

Suction Pump Oil Strainer Cleaning

and Inspection

Clean oil strainer with a part cleaner then use an

air gun to dry it.

Inspect rubber ring gaskets.

smr2006-014-020_a

1. Suct

ion pump cover gasket

2. Oil filler tube gasket

If rubber rings are brittle, cracked or hard, replace

them.

Clean both contact surfaces of oil suction pump

cover.

Chec

k and clean the oil inlet and outlet area for dirt

and o

ther contaminations.

smr2009-023 97

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [120/555] 12053

Похожие устройства