Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [121/555] 12053

Section 02 ENGINE

Subsection 08 (LUBRICATION SYSTEM)

smr2009-023-007_a

1. Oil inlet

2. Oil outlet

Suction Pump Oil Strainer Installation

For installation, reverse the removal procedure.

However, pay attention to the following.

Apply

LOCTITE 243 (BLUE) (P/N 293 800 060) on

threads of the suction pump cover screws and

tighten them to 9 N•m (80 lbf•in).

Position screws according to their length as

shown.

smr2009-023-008_a

1. Screws M6 x 25

2. Screws

stainless steel M6 x 45

Torque suction pump cover screws as per se-

quence illustrated below.

smr2009-023-009_a

TIGHTENING SEQUENCE

ENGINE OIL PRESSURE

REGULATOR

The oil pressure regulator is located on the bottom

of the PTO housing.

smr2007-015-005_a

TYPICAL

1. Oil pre

ssure regulator

NOTE: The oil pressure regulator system opens

when the oil pressure exceeds 400 kPa (58 PSI).

Oil Pressure Regulator Removal

Remove engine oil. See procedure in

OIL

CHANGE

in this subsection.

Remove

– Oil pressure regulator plug

– Compression spring

–Valve

piston

– Valve piston guide.

98 smr2009-023