Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [269/555] 12053
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [269/555] 12053

Sea-Doo RXT iS 2009 Инструкция по эксплуатации онлайн [269/555] 12044
Section 04 FUEL SYSTEM
Subsection 02 (ELECTRONIC FUEL INJECTION (EFI))
smr2009-030-036_a
1. MATS connector
Use the FLUKE 115 MULTIMETER (P/N 529 035 868)
and select .
Probe sensor terminals.
lmr200
6-021-004_a
The resistance should be as per following chart.
Otherwise, replace the MATS.
If resi
stance value is good, reconnect the MATS
and dis
connect the ECM connector A on the ECM.
Install the
ECM ADAPTER TOOL (P/N 529 036 166) to
ECM harness.
Probe adapter terminals as follows.
ECM ADAPTER MEASUREMENT
PIN RESISTANCE
A-J3 A-H3
See ta
ble below
TEMPERATURE RESISTANCE (OHMS)
°C °F NOMINAL LOW HIGH
- 30 - 22 12600 11800 13400
-20
-4
11400 11000 11800
-10
14
9500 8000 11,000
0 32 5900 4900 6900
10 50 3800 3100 4500
20 68 2500 2200 2800
30 86 1700 1500 1900
40 104 1200 1080 1320
50 122 840 750 930
60 140 630 510 750
70 158 440 370 510
80 176 325 280 370
90 194 245 210 280
100 212 195 160 210
110 230
145
125 160
120 248
115
100 125
vmr2008-022-005_a
If res
istance value is correct, check ECM. Refer to
ENGIN
E CONTROL MODULE (ECM)
in this sec-
tion.
If resistance value is incorrect, repair the connec-
tors or replace the wiring harness between ECM
connector and the MATS.
MATS R
eplacement
Open seat.
Remove rear ventilation box. Refer to
AIR INTAKE
SILENCER
.
Disco
nnect the connector of the MATS.
Screw MATS out and install the new one. Torque
to 17 N•m (150 lbf•in).
246 smr2009-030

Похожие устройства

Скачать