Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [456/555] 12053
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [456/555] 12053

Sea-Doo GTX Limited iS 2009 Инструкция по эксплуатации онлайн [456/555] 12053
Section 06 STEERING AND PROPULSION
Subsection 04 (DRIVE SHAFT)
2. Remove the damper at the end of drive shaft
andreplaceitwithaNEW one.
smr2006-028-004_a
1. Damper
3. Wipe clean
thesealingringandthecarbonseal
contact su
rfaces.
4. Properly align sealing ring with carbon seal.
smr2009-007-001_b
1. Sealing ring aligned with carbon seal
5. Wipe clean the threads and the tapered surface
on drive shaft.
6. Apply engine oil to the tapered surface on drive
shaft.
smr2009-007-016_a
1. Cle
an taper then coat with engine oil
7. Apply 2 beads of LOCTITE 577 (THREAD
SEALANT) (P/N 293 800 050)
on threads as
shown.
smr2009-007-010_a
LOCTITE 577 APPLICATION
A. First 5 threads
B. 3 mm (1/8 in)
8. From rear of watercraft, engage drive shaft
through the drive shaft boot.
9. Continue pushing drive shaft towards engine
carefully guiding it through the sealing ring, the
PTO seal and finally into the crankshaft splines.
NOTE: It may be necessary to move sealing ring
and PTO seal up and down to position them in the
same axis as the drive shaft.
NOTE: If drive shaft does not enter into the PTO
seal, check engine alignment. Refer to
ENGINE
subsection.
10. Trace an index mark on the drive shaft which
will be used for counting the turns the drive
shaft will be rotated to fully engage drive shaft.
smr2009-007-014_a
1. Mark
11. Instal
lthe
DRIVE SHAFT ADAPTER (P/N 529 035
985)
o
n drive shaft end.
smr2009-040 433

Похожие устройства

Скачать