Suunto Gekko Инструкция по эксплуатации онлайн [51/70] 12781

follow the procedure below:

1. Remove the computer from the console or boot.

Wrist model:

• Disassemble the shorter part of the strap with a ﬂ at 1.5 mm screwdriver or

a special tool for spring bars. The longer part of the strap may stay on but

removing it may ease the work later on.

Console model:

1. Remove the dive computer from the console according the instructions of

the console.

2. Thoroughly rinse and dry the computer.

3. Open the securing ring of the battery compartment lid by pushing it down

and rotating it clockwise. You may use a pointed nose pliers or a small

screwdriver as an aid in the rotating. Put the pliers ends into the holes of the

securing ring or the screwdriver onto the side of the right tooth on the ring

(Fig. 5.2) and turn the ring clockwise. Care should be taken not to damage

any of the parts.

4. Remove the ring.

5. Carefully remove the lid with the beeper attached to it. The lid can be

removed by pressing with your ﬁ nger on the outermost edge of the lid

while at the same time pulling with your nail at the opposite side. Do not

use sharp metal objects as they might damage the O-ring or the sealing

surfaces.

6. Remove the O-ring and the battery retainer.

7. Carefully remove the battery. Do not damage the electrical contacts or the

sealing surface.

Check for any traces of ﬂ ooding, particularly between the beeper and the lid, or

for any other damage. In case of a leak or any other damage, bring the dive

computer to an authorized SUUNTO dealer or distributor for check and

repair.

8. Check the condition of the O-ring; a defective O-ring may indicate sealing

or other problems. Dispose the old O-ring, even if it seems to be in good

condition.

9. Check that the battery compartment, battery holder and lid are clean. Clean

with soft cloth if necessary.

10. Gently insert the new battery in the battery compartment. Check the

polarity of the battery: the “-” mark should point toward the bottom of the

compartment and the “+” mark upwards.

11. Reinstall the battery retainer in its correct position.