![Suunto D6 Инструкция по эксплуатации онлайн [85/109] 12812](/img/pdf.png)
Suunto D6 Инструкция по эксплуатации онлайн [85/109] 12812
IMPORTANT: Your Suunto D6 should be soaked, then thoroughly rinsed with fresh
water and dried with a soft towel after each dive. Make sure that all salt crystals and
sand particles have been flushed out. Check the display for possible moisture or water,
and do not use the Suunto D6 if you detect any moisture or water inside.
CAUTION
•
Do not use compressed air to blow water off the unit.
•
Do not use solvents or other cleaning fluids that might cause
damage.
•
Do not test or use the dive computer in pressurized air.
8.4. Water resistance inspection
The water resistance of the unit must be checked after replacing the battery or after
other service operations. The check requires special equipment and training.
You must frequently check the display for any sign of leaks. If you find moisture inside
your dive computer, there is a leak. A leak must be corrected without delay, as moisture
will seriously damage the unit, even beyond repair. Suunto does not take any
responsibility for damage caused by moisture in the dive computer, if the instructions
of this manual have not been carefully followed.
In the event of a leak, immediately take the dive computer to an authorized Suunto
representative.
85
Содержание
- S t c a t n o c e c i v r e s r e m o t s u c 2
- Table of contents 3
- Welcome to the world of suunto diving instruments 7
- Warnings cautions and notes 9
- Note if no button is pressed for 5 minutes the dive computer beeps and returns to the time mode automatically 15
- Suunto d6 at a glance 15
- Navigating in the menus 16
- Button symbols and functions 17
- Getting started with your suunto d6 19
- Time mode settings 19
- Setting the alarm 20
- Setting the dual time 21
- Setting the time 21
- Setting the date 22
- Setting the units 22
- Setting the backlight 23
- Setting the tones 23
- Stopwatch 24
- Stopwatch the suunto d6 s stopwatch measures elapsed and split times a separate stopwatch dive timer can also be used when in gauge mode see section 6 diving in gauge mode divegauge 24
- Ac water contacts 25
- Learning how to use your compass 26
- Compass display 27
- Locking a bearing 28
- Compass settings 29
- Before diving 32
- Note the settings cannot be activated until 5 minutes has elapsed after the dive 41
- Setting the depth alarm you can set a depth alarm in the dive computer 41
- Diving 56
- Decompression will now begin but is very slow you should therefore continue your ascent 64
- Display at the ceiling zone when you reach the ceiling zone the display will show you two arrows pointing at each other the hour glass icon below is an example of a decompression dive at the ceiling zone 64
- After diving 72
- Care and maintenance 83
- Technical data 87
- Intellectual property 96
- Disclaimers 97
- Warranty 99
- Disposal of the device 101
- Glossary 102
Похожие устройства
- Yamaha PSR-450 Инструкция по эксплуатации
- Dekok Uka-1320 Инструкция по эксплуатации
- Mega T 250 F BS 5,0 Инструкция по эксплуатации
- Samsung GT-B5512 Galaxy Y Pro Duos Инструкция по эксплуатации
- JVC TH-A55 Инструкция по эксплуатации
- Samsung GT-S6102 Galaxy Y Duos Инструкция по эксплуатации
- Suunto D4i Инструкция по эксплуатации
- Yamaha PSR-550 Инструкция по эксплуатации
- Kenwood MG-510 Инструкция по эксплуатации
- Efco МZ 2090 RX GX160 45009 (EXTRA UE)68699077 Инструкция по эксплуатации
- JVC TH-A35 Инструкция по эксплуатации
- Suunto Combo Инструкция по эксплуатации
- Huter GMC-7.0 Инструкция по эксплуатации
- Samsung SGH-i717 Galaxy Note Инструкция по эксплуатации
- Yamaha PSR-A300 Инструкция по эксплуатации
- Kenwood MG-470 Инструкция по эксплуатации
- Dekok UKA-1210 Инструкция по эксплуатации
- JVC TH-A30R Инструкция по эксплуатации
- Suunto Cobra3 Инструкция по эксплуатации
- Yamaha PSR-E203 Инструкция по эксплуатации