Kramer VM-30AV [7/13] Using your audio video da

Using Your Audio/Video DA

Table 1 and Table 2 define the front and rear panels of the VM-30AV and the

VM-30AVB, respectively.

Table 1: Front Panel VM-30AV and VM-30AVB 1:3 Audio/Video DA Features

Table 2: Rear Panel VM-30AV and VM-30AVB 1:3 Audio/Video DA Features

5 Using Your Audio/Video DA

Section 5.1 describes how to connect a VM-30AV/B

. Section 5.2 describes

how to configure a 1:3 Audio/Video DA for component video (YUV) or

RGB. You can also use the VM-30AV/B, with its very high frequency, to

process SDI (serial digital interface) video.

5.1 Connecting your VM-30AV/B

2. Connect

the 3 VIDEO OUT connectors

4

and the left and right AUDIO OUT

Insert a screwdriver into the small hole and carefully rotate it, to trim the appropriate level

From this section on, both machines are referred to as VM-30AV/B

Switch OFF the power on each device before connecting it to your VM-30AV/B. After connecting your VM-30AV/B,

switch on its power and then switch on the power on each device