Kramer RC-76M [11/25] Installing the rc 76m rc 712m

RC-76M/ RC-712M - Installing the RC-76M/RC-712M

4 Installing the RC-76M/RC-712M

To install the RC-76M/RC-712M:

 Configure the buttons

 Connect the cables

 Mount the room controller onto the Merten compatible housing

 Attach button caps with labels

 Place the frame

 Attach the faceplates

4.1 Configuring the Room Controller Buttons

Configure the 6 buttons for RC-76M and 12 buttons for RC-712M using the

K−Config configuration software via the USB port that is located on the front panel

on the board or the Ethernet port located on the rear panel. Use the IR learning

receiver on the front panel to read IR commands from any IR remote control. Note

that the device needs to be connected to the power to configure the buttons. The

K-Config user guide is available on our Web site at

http://www.kramerelectronics.com/support/product_downloads.asp

We recommend that you configure the buttons before mounting the

device onto the Merten compatible on-wall box.

4.2 Mounting the Device

This section describes how to mount the RC-76M/RC-712M onto the Merten

compatible on-wall box (sold by Kramer, P/N: OWB-2G/M).

4.2.1 Connecting the Ports

The following diagrams illustrate a compatible 2 gang on- wall box, but installation

is similar with any compatible wall box.

We recommend that you first detach the male connectors from the rear

panel, connect the relevant wires to them and then reconnect the

assembled male terminals to the unit just before installation in the on-wall

box.