Smeg SI4631CB [13/14] During initial use
![Smeg SI4631CB [13/14] During initial use](/views2/1015280/page13/bgd.png)
EN
13
44
/ SPECIAL MESSAGES, DIFFICULTIES
Warning
In the event that there is a break, crack or opening--even minor--in the vitroceramic
glass, immediately disconnect your appliance to avoid the risk of electric shock.
Contact the After-Sales Service Department.
YOU OBSERVE THAT: POSSIBLE CAUSES: WHAT SHOULD YOU DO:
An indicator light appears.
Your installation blows a fuse.
Only one side works.
The hob produces an odour
during the first cooking ses-
sions.
Working normally.
The electrical hook-up of your
hob is incorrect.
New appliance.
Nothing.
Verify the connections.
See the "Hook-Up" sec-
tion.
Operate each cooking
zone for 30 minutes with a
saucepan full of water.
The hob stops working and it
emits a beep approximately
every 10 seconds and a or
"F7" is displayed.
A series of small or "F7" is
displayed.
After turning on a heating zone,
the indicator lights on the
control panel continue to flash.
The saucepans make noise
during cooking.
Your hob makes a clicking
sound during cooking.
The fan continues to function a
few minutes after your hob is
turned off.
There was an overflow or an
object is in contact with the
control panel.
The electronic boards heated
up.
The cookware used is not sui-
table for induction or is less
than 12 cm in diameter (10 cm
for the 16-cm cooking zone).
This is normal with some types
of cookware. This is caused by
the transfer of energy from the
hob to the cookware.
Cooling of the electronic com-
ponents.
Working normally.
Clean the hob or remove
the object, then begin
cooking again.
See "Built-In" section.
See section on cookware
for induction.
Nothing. There is no risk,
neither to your hob nor to
your cookware.
Nothing.
•
During operation
•
During initial use
YOU OBSERVE THAT: POSSIBLE CAUSES: WHAT SHOULD YOU DO:
The hob is not working and the
indicator lights on the control
panel are not on.
The table is not working and
another message is displayed.
The hob does not function, the
information
is displayed.
The appliance is not receiving
electricity. The electrical sup-
ply is defective or the hook-up
is incorrect.
The electronic board is func-
tioning poorly.
The hob is locked.
Inspect the electrical cir-
cuit breaker and fuses.
Call the After-Sales
Service Department.
See chapter on using the
child safety system.
•
When powering on
YOU OBSERVE THAT: POSSIBLE CAUSES: WHAT SHOULD YOU DO:
Содержание
- Cz5701111_00_fr pdf 1
- Table de cuisson cooking hob placa de cocción placa de cozinha kochfeld piano di cottura 1
- As part of our commitment to constantly improving our products we reserve the right to make changes to them based on technical advances to their technical and functio nal features and appearance 2
- Before installing and using your appliance please carefully read this guide to installation and use which will allow you to quickly familiarise yourself with its ope ration 2
- Cooking chart 2
- Daily care of your appliance 2
- Installing your appliance 2
- Special messages difficulties 2
- Table of contents 2
- Using your appliance 2
- Warning 2
- Child safety device 3
- Electrical danger 3
- Environmental protection 3
- For users of pacemakers and active implants 3
- Residual heat 3
- Safety guidelines 3
- Air intake 4
- Air outlet 4
- Description of your appliance 4
- Power cord 4
- Vitroceramic glass 4
- Building in 5
- Choosing the position 5
- 240 v monophase hook up 6
- Hook up 6
- Hook up 400v 2n 6
- Installing your appliance 6
- Warning 6
- Description of the top 7
- Si 4631 7
- Si 4631cbs 7
- Using your appliance 7
- Cookware 8
- Cookware for induction 8
- The induction principle 8
- Which cooking zone should you use based on your cookware 8
- Adjusting the power level 9
- Description of the controls 9
- Operation 9
- Setting the timer 9
- Using your appliance 9
- Child safety use 10
- Clean lock 10
- Hob locked when in operation 10
- How do you lock your hob 10
- How do you unlock your hob 10
- The hob is locked when switched off 10
- Using your appliance 10
- Auto stop system 11
- Protection against overflows 11
- Residual heat 11
- Safety during operation 11
- Small items safety 11
- Temperature limiter 11
- Using your appliance 11
- Warning 11
- Daily care of your appliance 12
- Maintaining your appliance 12
- Protecting your appliance 12
- During initial use 13
- During operation 13
- Special messages difficulties 13
- Warning 13
- When powering on 13
- Cooking chart 14
- Cz5701111 00 09 11 14
Похожие устройства
- Champion GHP40-2 Инструкция по эксплуатации
- Miele DA 3160 EXT Инструкция по эксплуатации
- Ardo 66GE40 W Инструкция по эксплуатации
- Acer ASPIRE 5253G-E352G25Mncc Инструкция по эксплуатации
- Smeg SI3321B Инструкция по эксплуатации
- Champion GP50 Инструкция по эксплуатации
- Miele DA 3160 Инструкция по эксплуатации
- Ardo A 56V4 ED WHITE Инструкция по эксплуатации
- Electrolux EWC1150 Инструкция по эксплуатации
- Smeg CO68CMA8 Инструкция по эксплуатации
- Koshin SEM-50V Инструкция по эксплуатации
- Ardo PL 998 XS Инструкция по эксплуатации
- Miele DA 289-4 EXT Инструкция по эксплуатации
- Electrolux EWS125410A Инструкция по эксплуатации
- Smeg PGF30B Инструкция по эксплуатации
- Спец PB15C Инструкция по эксплуатации
- Ardo 56GG40V X Инструкция по эксплуатации
- Miele DA 289-4 Инструкция по эксплуатации
- Electrolux EWW126410W Инструкция по эксплуатации
- Спец PB20H Инструкция по эксплуатации
Скачать
Случайные обсуждения
Ответы 0
Отключить режим SH. По инструкции ничего не понятно. Помогите по шагам, что делать
7 месяцев назад