Kramer VM-114H [13/22] Using the vm 114h 2x input 1 4 hdmi da

VM-114H - Using the VM-114H 2x Input 1:4 HDMI DA

5 Using the VM-114H 2x Input 1:4 HDMI DA

This section describes how to acquire the EDID (see Section 5.1) and how to

connect via RS-232 (see Section 5.3).

5.1 Selecting an Active Input

To select an active input:

 Press the INPUT SELECTOR button until the required INPUT LED lights

5.2 Acquiring the EDID

Each input on the VM-114H has a factory default EDID loaded in non-volatile

memory (see Section 8). This lets you connect the power before having to connect

one of the acceptors.

You can acquire the EDID from:

This is usually done only once when the machine is being set up in an installation. Once

acquired, the EDID is saved in non-volatile memory and further acquisition is not necessary

 One output (the relevant output LED flashes)

 The default EDID (all output LEDs flash)

 Up to four connected outputs using the Auto-mix Mode (all output LEDs light)

The EDID acquired is a weighted average of all the connected outputs. For example, if

several displays with different resolutions are connected to the outputs, the acquired

EDID supports all the resolutions, as well as other parameters included in the EDID

To acquire the EDID:

1. Connect the output(s) from which you want to acquire the EDID.

2. Press the EDID SELECT button briefly.

The device enters the EDID programming mode. The last acquired EDID is

indicated by the lit LED (for example, if Output LED 2 is lit, the EDID

acquired was from Output 2).

3. Press the EDID SELECT button repeatedly until the required EDID is

indicated based on the patterns described above.