Kramer 914 [10/17] Connecting the 914

914 - Connecting the 914

5 Connecting the 914

This chapter comprises the following sections:

 Connecting the 914 (see Section 5.1)

 Connecting the remote controls (see Section 5.2)

 Connecting the speakers (see Section 5.3)

5.1 Connecting the 914

Always switch off the power to each device before connecting it to your

914. After connecting your 914, connect its power and then switch on

the power to each device.

To connect the 914 as illustrated in the example in Figure 3:

1. Connect the balanced, stereo audio source (for example, a multimedia

player) to the INPUT 5-pin terminal block (see Section 5.4).

2. Connect the Speaker Out terminal block to a pair of speakers. Connect the

left speaker to the L+ and L– pins, and the right speaker to the R– and R+

pins (in stereo mode). For bridged mono mode, see Section 5.3.

Note: Do not ground the speakers.

3. Optional—Connect the GND, LEVEL and V+ pins on the 10V CONTROL

terminal block connector to a remote 10kΩ volume control.

4. Optional—Connect the Standby and Mute pins to remote control switches

(see Section 5.2).

5. Connect the supplied power cord to the 914 power socket and to the mains

electricity (not shown in Figure 3).

6. Adjust the volume using the Level control on the rear panel.