AM.PM sense f7510000, для ванны и душа [6/28] F7583100

Operating pressure range in the water mains is 1.5 – 6.0 atm (120-600kPa). Pressure difference for hot and cold

water can vary + / - 10%. If pressure parameters in the water mains differ from the speciﬁ ed value, input pressure

increase or input pressure relief device is required.

To avoid ingress of solids (abrasive particles) in the mixing valve, it is recommended to apply 100-300 micron ﬁ lters.

1. Close off hot and cold water supply. Screw in the ﬂ at-end reducers. Screw in the eccentric adapters in water

supply piping outlets with pre-sealing of the threaded part with insulating material. Adjust the position of eccentric

reducers so that they match and meet the connecting position of the mixing valve, and the mixing valve is horizontal

(distance between the eccentrics – 150mm OC).

2. Remove (unscrew) the aerator (to avoid clogging the aerator at the ﬁ rst start-up of water).

3. Fasten the trim to the eccentric reducers, using tool with soft parts (to avoid damage to the decorative coating of

mixing valve nuts), mount the valve housing.

4. Turn on the water supply. In the closed position

of the valve, check sealing of all the connections. If

necessary, make extra tightening and sealing of the

connections (be sure to close off the water supply).

5. Attach the shower hose and the shower head.

6. Start the cold and hot water running for a short

period of time, then close the water supply and

install (tighten) the aerator.

F7500000

F7583100

F7504000

调合器安装说明

清洗、盆浴、洗涤调合器（安装水平表面）

F7502100/F7582100