AM.PM sense f7520000 [4/28] F7590000

Operating pressure range in the water mains is 1.5 – 6.0 atm (120-600kPa). Pressure difference for hot and cold

water can vary + / - 10%. The recommended pressure is 2.5 atm. If pressure parameters in the water mains differ

from the speciﬁ ed value, input pressure increase or input pressure relief device is required.

To avoid ingress of solids (abrasive particles) in the mixing valve, it is recommended to apply 100-300 micron ﬁ lters.

1. Close off hot and cold water supply.

2. Remove (unscrew) the aerator (to avoid clogging the aerator at the ﬁ rst start-up of water).

3. Connect the ﬂ exible hoses to the valve. The ﬂ exible hoses should be screwed into the valve slot only by hand

without using tools or applying excessive force, because this can cause damage the hoses or the valve.

4. Fasten the mixing valve on the sanitary ware, using the supplied fasteners.

5. Connect the valve to the water supply system, using the connecting ﬁ ttings (upset couplings). Turn on the water

supply. In the closed position of the valve, check sealing of all the connections. If necessary, make extra tightening

and sealing of the connections (be sure to close the shut-off valves on water supply piping).

6. Start the cold and hot water running for a short period of time (to wash off the pipes), then close the water supply

and install (tighten) the aerator.

浴缸调合器（调整垂直表面）

F7510000

F7590000

F7520000