APC Smart-UPS SMT2200RMI2U Инструкция по эксплуатации онлайн

Installation Guide Smart-UPS

™

750/1000/1500/2200/3000 VA 100/120/230 Vac

Rack-Mount 2U

Important Safety Messages

Read the instructions carefully to become familiar with the equipment before trying to install, operate, service or

maintain it. The following special messages may appear throughout this manual or on the equipment to warn of

potential hazards or to call attention to information that clarifies or simplifies a procedure.

The addition of this symbol to a Caution product safety label indicates that an electrical hazard exists

which will result in personal injury if the instructions are not followed.

The following safety messages may appear throughout this manual to warn of potential

hazards.

Safety and General Information

Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damage.

Read the Safety Guide supplied with this unit before installing the UPS.

• Adhere to all national and local electrical codes.

• This UPS is intended for indoor use only.

• Do not operate this UPS in direct sunlight, in contact with fluids, or where there is excessive dust or

humidity.

• Be sure the air vents on the UPS are not blocked. Allow adequate space for proper ventilation.

• The battery typically lasts for two to five years. Environmental factors impact battery life. Elevated ambient

temperatures, poor quality utility power, and frequent short duration discharges will shorten battery life.

• Connect the UPS power cable directly to a wall outlet. Do not use surge protectors or extension cords.

• The equipment is heavy. Always practice safe lifting techniques adequate for the weight of the equipment.

• The batteries are heavy. Remove the batteries before installing the UPS and XLBP in a rack.

• Always install external battery packs (XLBPs) at the bottom in rack-mount or stack configurations. The UPS

must be installed above the XLBPs.

• Always install peripheral equipment above the UPS in rack-mount or stack configurations.

• The UPS will recognize as many as 10 external battery packs connected to the UPS. However there is no

limit to the number of XLBPs that can be used with the UPS.

• The model and serial numbers are located on a small, rear panel label. For some models, an additional label is

located on the chassis under the front bezel.

• Always recycle used batteries.

• Recycle the package materials or save them for reuse.

CAUTION

CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage and minor or

moderate injury.

CAUTION

CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage.