Beko CN 327120 S [30/84] Instruction for use

Содержание

Instruction for use Transport instructions The appliance should be transported only in upright position Before the performance of the working test in the shop the packing of the appliance must be intact After a transport in the horizontal position the device may only be taken into operation 4 hours after being stood up vertically again The appfiance must be protected against rain moisture and other atmospheric influences The manufacturer assumes no liability if safety instructions are disregarded Disposal Make the device unusable immediately Pull out the mains plug and cut the power cable Remove or destroy snap or latch locks before disposing of the device In this manner you prevent children from locking themselves in and endangering their lives Device setup The climate class rate of your appliance is given in Technical Features leaflet and written on the rating label inside the appliance It specifies the appropriate operating ambient temperatures as explained below Climatic class Ambient temperatures SN from 10 C to 32 C N from 16 C to 32 C ST from 18 C to 38 C T from 18 C to 43 C SN ST from 10 C to 38 C SN T from 10 C to 43 C Location Only place the appliance as shown in the illustration in dry rooms which can be aired Avoid direct sunlight or direct heat sources such as a stove or a heater If this cannot be avoided the following minimum distances should be maintained Electric stoves 3 00 cm Heater 3 00 cm Cooling devices 2 50 cm Ensure sufficient air circulation for your device Make sure that sufficient room is provided around the appliance to ensure free air circulation picture 3 Fit the two plastic wall spacers supplied With the appliance rotating 1 4 turn to the condenser at the back of the appliance picture 4 The appliance should be located on a smooth surface The two front feet can be adjusted as required picture 5 To ensure that your appliance i standing upright adjust the two front feet by turning clockwise or counter clockwise until the product is in firm contact with the floor Correct adjustment of feet avoids excessive vibration and noise Never plug and turn on the refrigerator without removing of the styrofoam transport cubes between the cabinet and the tray on the compressor Never plug and turn on the refrigerator if the tray is located incorrectly or if the tray is not placed on the compressor Water tray is used to collect the water on the compressor picture6 in order to avoid water dropping onto the electrical parts of the compressor A water tray must stay horizontally without inclination Do not operate your appliance in a room where the temperature is likely to fall below 10 C at night and or especially in winter At lower temperatures the appliance may not operate resulting in a reduction in the storage life of the food 6 I EN