Bomann KB 289 [5/8] Everse

5

03/2012

INSTALLATION

Location

Sufficient ventilation around the device is necessary in order for the heat to dissipate properly and to

guarantee efficient cooling operation at low power consumption. For this purpose, leave sufficient

space around the device.

- Minimum clearance of 7.5 cm between rear side and wall,

- Do not use the device outdoors.

- Only install at a location with an ambient temperature suitable for the climate class of the device.

For information on the climate class, please refer to chapter “Specifications“ or to the rating label

located in the interior or on the rear side of the device.

- Avoid installation at locations with high humidity (e.g. outdoors, bathroom), as metal parts would be

susceptible to corrosion under such circumstances.

- Do not place the device near volatile or combustible materials (e.g. gas, fuel, alcohol, paint, etc.)

and in rooms which may have poor air circulation (e.g. garages).

- Only place on a steady and safe surface.

- If the device is not horizontally leveled, adjust the feet accordingly.

freely accessible.

Mains cable

- Do not extend or roll up the cable during operation.

- Also, the cable must not be near the compressor on the rear side, since latter one gets hot during

operation. In case of any contact, the isolation would be damaged resulting in electric leakage.

- The use of extension cables is not recommended.

- Do not connect the device to the mains with wet hands.

- Install the device for the wall socket to be freely accessible.

- Use a screw-driver to remove the hinge cover (3) and the blind plug (1).

- Tilt the device slightly backwards and block it in this position.

(1) Blind plug

(2) Separate Foot

(3) Hinge cover

(7) Screws

(8) Foot

(9) Blind plug